300-510 Practice Questions
298 real 300-510 exam questions with expert-verified answers and explanations. Page 6 of 6.
- Question #254Routing Policy and Manipulation
Refer to the exhibit. OSPF is an interior routing protocol on the network. R2 is in the backbone area, and R4 is in a totally NSSA area. R5 announces only the 0.0.0.0/0 route to R4...
OSPF NSSAOSPF LSA Type 7OSPF LSA Type 5Route RedistributionForwarding Address (FA) - Question #255Multicast Routing
SIMULATION Guidelines This is a lab item in which tasks will be performed on virtual devices. - Refer to the Tasks tab to view the tasks for this lab item. - Refer to the Topology...
PIM Sparse ModeIGMPRendezvous Point (RP)Any-Source Multicast (ASM) - Question #256Routing Policy and Manipulation
Refer to the exhibit. An engineer is comparing these RPL and route map configurations. Which two conclusions will the engineer reach? (Choose two.)
BGPRoute Policy Language (RPL)Route MapsBGP Attributes - Question #257Core Routing
What is the purpose of the confederation identifier in a BGP confederation?
BGP ConfederationAS NumberiBGP Scaling - Question #258Core Routing
SIMULATION Guidelines This is a lab item in which tasks will be performed on virtual devices. - Refer to the Tasks tab to view the tasks for this lab item. - Refer to the Topology...
BGP PeeringBGP Route AdvertisementBGP Route SummarizationBGP Next-Hop - Question #259Routing Policy and Manipulation
Which requirement must be met while using parameter with conditional matching in routing policy definition?
Routing PolicyPolicy Language SyntaxIOS XR Parameters - Question #260Routing Policy and Manipulation
How does conditional matching operate with RPL?
Routing PolicyRPLConditional MatchingRoute Manipulation - Question #261Core Routing
A network administrator working for a private service provider with an employee ID: 4872:46:269 wants to configure timers for the BGP process on their Cisco IOS XE router. Which co...
BGPBGP TimersCisco IOS XEConfiguration - Question #262Routing Policy and Manipulation
Refer to the exhibit. The service provider environment has these configurations: - The OSPF backbone area is configured to advertise loopback prefixes. - The PE routers run the BGP...
BGPRoute RedistributionStatic RoutingRoute Stability - Question #264MPLS and Segment Routing
Refer to the exhibit. All backbone interfaces on the network are in VRF_MPLS and ip rsvp signaling hello is preconfigured on all MPLS routers in the network. After router R2 was up...
MPLS RSVPVRFRSVP HellosTroubleshooting MPLS - Question #265MPLS and Segment Routing
Which attribute is used to instruct the router that packets must be processed by an ASA that is associated with the segment?
Segment RoutingService SIDService Function ChainingNetwork Services - Question #266
Refer to the exhibit. ISP_1 uses eBGP for connection to all clients. LDP with OSPF and IS-IS is used in the ISP_1 network. Client_A and Client_B are in the same VRF_VoD. After a so...
- Question #267MPLS and Segment Routing
Refer to the exhibit. The network is situated at different locations on the customer site. The customer runs a mission-critical application behind CE2, which is connected over a 10...
MPLSLSPOSPFLoopback Interface - Question #268MPLS and Segment Routing
A network engineer must implement a segment routing policy rule that specifies that SIDs are bounded manually. The policy will be used for traffic steering based on incoming label...
Segment RoutingSRLBBinding SIDMPLS Labels - Question #269MPLS and Segment Routing
Refer to the exhibit. A network engineer must enable connections from customers on PE1 to the external network via the SR-MPLS forwarding plane with a range of 8000 SID. In the cur...
Segment RoutingISISMPLSNode-SID - Question #270Service Provider VPN Services
What is a restriction of 6PE?
6PEIPv6 over MPLSVRF limitationMP-BGP - Question #271Service Provider VPN Services
Refer to the exhibit. Dedicated MPLS Layer 3 services for VRF customer A are configured on the MPLS network for FTP access. OSPF with area 0 configuration is used as the interior r...
MPLS L3 VPNCEFTroubleshootingData Plane - Question #272MPLS and Segment Routing
Refer to the exhibit. Router 1, Router 2, and Router 3 are co-located in an onsite data center of an office, but Router 4, Router 5, and Router 6 are installed in another data cent...
MPLS-TEFast Reroute (FRR)RSVP-TE LSPsNetwork Resilience - Question #273Routing Policy and Manipulation
Refer to the exhibit. IS-IS runs in the network and all routers are in the same area R1 statically routes to distribute traffic with R6 and the networking team has redistributed th...
IS-IS RedistributionIS-IS Metric StylesRoute ManipulationNetwork Troubleshooting - Question #274Service Provider VPN Services
Refer to the exhibit. After maintenance to activate BGP neighbors connecting a new data center attached to R1, L3VPN customers attached to OSPF domain 100 lost connectivity to serv...
BGP Maximum-PrefixL3VPN ConnectivityMP-BGPService Provider Troubleshooting - Question #275Unicast Routing
Refer to the exhibit. A company has been running OSPF and EIGRP on two separate portions of the network. To allow communication flow between these previously isolated parts of the...
OSPF RedistributionEIGRP RedistributionClassless RoutingInter-protocol Routing - Question #276Unicast Routing
Which type of policy does an IPv6 ISATAP tunnel support?
IPv6 Transition MechanismsISATAPIPv6 TunnelingIPv6 Routing - Question #277MPLS and Segment Routing
Refer to the exhibit. Routers R1 and R2 are RFC 5036-based MPLS-enabled core routers MPLS IP is enabled globally on both routers OSPF with area 0 configuration is used as an interi...
MPLS LDP ConfigurationOSPF IntegrationLDP Router ID ReachabilityMPLS Troubleshooting - Question #278MPLS and Segment Routing
Refer to the exhibit. A regional service provider provides connectivity for several midsize businesses that run mission-critical applications between multiple offices connected via...
Segment RoutingSR-TE ProtectionHigh AvailabilitySRLG - Question #279Service Provider VPN Services
Refer to the exhibit. The service provider provides IPv6 connectivity to large enterprise customers with offices spanning several geographic regions SRv6 is running in the service...
SRv6IPv4 over IPv6VPN ServicesData Plane - Question #280Core Routing
Refer to the exhibit. AJI four routers on the network reside in the same data center. The four routers are running IS-IS between them in Level 1 mode within an IPv4 network. After...
IS-ISLevel 1/Level 2 routingArea designRouting connectivity - Question #281Unicast Routing
Refer to the exhibit. EBGP peering is up between BGP AS 65101 and BGP AS 65201. The service provider expects traffic convergence within 300ms between the two autonomous systems but...
BGPBFDFast ConvergenceEBGP - Question #282MPLS and Segment Routing
Refer to the exhibit. Early in the growth cycle of a small enterprise the network-engineering team implemented segment routing to support automation of the IPv4 network. As the net...
Segment RoutingSRv6Flexible AlgorithmPath Manipulation - Question #283Unicast Routing
What are two major differences between OSPF and IS-IS routing protocols? (Choose two.)
OSPFIS-ISRouting Protocol DifferencesEncapsulation and Election - Question #284Routing Policy and Manipulation
RPL has several fundamental capabilities that differ from those present in configurations oriented to traditional route maps Routing policy language introduces the notion of sets....
Routing Policy Language (RPL)RPL setsPolicy manipulationBGP policy - Question #285Multicast Routing
Which fact must a network architect consider when implementing IGMP in a multicast routing environment?
IGMPMulticast RoutingSSMIGMPv3 - Question #286Core Routing
Which BGP well-known attributes are preserved between peers with a BGP confederation?
BGP ConfederationsBGP AttributesiBGP Attribute PropagationLocal-Preference - Question #287Unicast Routing
Refer to the exhibit. A network engineer at a large ISP with an employee ID 487694052 started to configure OSPF on two routers. The engineer notices that router 1 learned about net...
OSPF configurationNetwork advertisementRouting protocol troubleshootingWildcard masks - Question #288High Availability and Security
The engineering team at ISP_1 must improve network stability time and minimize the impact of routing instabilities from other domains to unicast transit services in the backbone R1...
OSPFNon-Stop Forwarding (NSF)Graceful RestartRouting Stability - Question #289MPLS and Segment Routing
Refer to the exhibit. The service provider deployed segment routing in its core. P2 is connected to P3 and P4 via a point-to-multipoint link as shown. The service provider provides...
Segment RoutingSR-P2MPTree-SIDMulticast - Question #290Unicast Routing
Refer to the exhibit. A growing company with multiple internal networks asked the network- engineering team to improve communication between its internal networks, focusing on effi...
IS-ISAdjacencyRouting ProtocolsIS-IS Levels - Question #291Core Routing
Refer to the exhibit. OSPF is configured in the network. The company operates several business units in a single building. To bring in a new business unit, which is located on a di...
OSPF AreasVirtual LinkInter-area RoutingOSPF Design Rules - Question #292Unicast Routing
Refer to the exhibit. A network engineer is installing two new routers to connect a small company's headquarters via router R1 and a branch office via R2. The engineer configured O...
OSPFABRArea ConfigurationRoute Advertisement - Question #293Multicast Routing
Refer to the exhibit. A network engineer is troubleshooting PIM-SM multicast that connects to multiple domains using MSDP. All BGP neighbors are up. and the devices are able to rea...
MSDPRPF CheckInter-domain MulticastBGP Peering - Question #294Multicast Routing
Refer to the exhibit. A host connected to router RD is attempting to connect to a new server on router RA to stream multicast data. PIM-SM is configured in the network, but multica...
Multicast RoutingPIM-SMRPFStatic Multicast Route - Question #295Multicast Routing
Which PIM message populates the outgoing interface list?
PIMMulticast RoutingJoin/Prune messagesOutgoing Interface List - Question #296Multicast Routing
Refer to the exhibit. The network is configured for multicast using PIM-SM. A server connected to R3 streams multicast data to hosts located on R4. To support expected growth in th...
Multicast RoutingPIM-SMAuto-RPRendezvous Point - Question #297Multicast Routing
Refer to the exhibit. PIM-SM has been enabled in the network, and the RP is located on R1 with IP address 20.20.20.1/24. After the team upgraded the networking stack on APP_Server...
Multicast TTLPIM-SMMulticast TroubleshootingApplication Server Configuration - Question #298MPLS and Segment Routing
Refer to the exhibit. A regional service provider provides connectivity for a growing enterprise, which recently acquired a new location in a nearby city. The new location, which i...
Segment RoutingIS-ISTraffic EngineeringService Provider Core - Question #299MPLS and Segment Routing
Refer to the exhibit. A Tier 1 ISP provides connectivity services to two regional ISPs, ISP1 and ISP2, leveraging the MPLS network. OSPF is used as an internal routing protocol, an...
MPLSTroubleshootingService Provider NetworksData Plane - Question #300MPLS and Segment Routing
Refer to the exhibit. An enterprise is running OSPF within its network. Cisco Express Forwarding is enabled on all connected links between routers. Users on the network report that...
MPLS LDPLabel DistributionMPLS TroubleshootingMPLS Forwarding - Question #301MPLS and Segment Routing
Refer to the exhibit. The networking team configured segment routing in the network with a unique range of labels assigned to each router. However, the maintenance of the network i...
Segment RoutingSRGBMPLSNetwork Simplification - Question #302Core Routing
Refer to the exhibit. ISP_1 uses OSPF and LDP in the backbone. Client_A and Client.B are in the same VRF_Shared. An iBGP session with address family VPNv4 is established between R6...
OSPFCore RoutingMPLS VPNTroubleshooting