300-510 Exam Questions

For which reason can two devices fail to establish an OSPF neighbor relationship?

Refer to the exhibit. Which LSA type is indicated by this router output?

After you change the IP address on an IOS XR router, you cannot ping the new address. Which step did you forget to complete?

Which cost is the default when redistributing routes from BGP to OSPF?

Refer to the exhibit. An engineer is troubleshooting an OSPF issue. Router 1 has a neighbor relationship with router 2. Only router 1 classful EIGRP routes can be seen on router 2....

Refer to the exhibit. A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and...

Refer to the exhibit. CE1 and CE2 cannot communicate through the service provider BGP peering is established between PE1 and PE2. IS-IS is the only routing protocol running in the...

Refer to the exhibit. Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?

Refer to the exhibit. Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?

Refer to the exhibit. Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally. Which two statements describe...

Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reach...

Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?

Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?

A network engineer is troubleshooting OSPF multiarea. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

Refer to the exhibit. After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?

For which reason can two BGP peers fail to establish a neighbor relationship?

In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?

Which statement about BFD on Cisco IOS XR Software is true?

Which two routing protocols have extensions capable of running SRv6? (Choose two.)

Refer to the exhibit. A network engineer implemented this segment routing configuration. Which statement about the output is true?

Refer to the exhibit. CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must b...

Which two characteristics unique to SSM when compared to ASM are true? (Choose two.)

Which two functions are supported for BGP extension MP-BGP for IP multicasting? (Choose two.)

In Cisco IOS-XR, the maximum-prefix command, to control the number of prefixes that can be installed from a BGP neighbor, is configured under which configuration mode?

Refer to the exhibit. Which tree does multicast traffic follow?

Refer to the exhibit. After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most...

Refer to the exhibit. Which effect of this configuration is true?

A network engineer of an ISP using Cisco IOS XR routers wants to limit the number of prefixes that BGP peers can accept. To accomplish this task, the command maximum-prefix 1000 is...

A network engineer for an ISP wants to reduce the number of iBGP adjacencies. A merge is taking place with another ISP network, so the network engineer needs to make both ASNs look...

A network engineer must configure a Cisco IOS XR router with BGP dampening. Which configuration meets these parameters?

Refer to the exhibit. XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network...

Refer to the exhibit. Router 1 is connected to router 2 on interface TenGigE0/1. Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and r...

Refer to the exhibit. A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing...

Refer to the exhibit. Router 1 is a core ABR in a Cisco Unified MPLS environment. All of the router 1 BGP peers are established, but traffic between customers is failing. Which BGP...

What can be used to determine a path from the head-end to a tail-end router when implementing SR-TE with a head-end, with little information on the network topology?

Refer to the exhibit. R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3 is in BGP AS 3. Assume that there is no connectivity issue between R1, R...

Refer to the exhibit. Router 1 has established an SR-TE tunnel with router 2. Which statement describes this configuration?

Which two conditions must be met before separate ISPs can provide interdomain multicast routing? (Choose two.)

Which three methods can be used to reduce the full-mesh IBGP requirement in a service provider core network? (Choose three.)

What is one of the configuration errors within an AS that can stop a Cisco IOS-XR router from announcing certain prefixes to its EBGP peers?

What is enabled by default on Cisco IOS-XR routers and cannot be disabled?

Which statement about enabling segment routing for IGPs is true?

Which task is performed when troubleshooting LDP?

An engineer is troubleshooting a connectivity issue across the MPLS network and is verifying the forwarding behavior of packets. Which table does the engineer look at to verify the...

You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up. Which task do you perform to begin troub...

Refer to the exhibit. Why is neighbor 10.1.5.5 stuck in "2WAY" state?

Refer to the exhibit. A network operator is working to filter routes from being advertised that are covered under an aggregate announcement. The receiving router of the aggregate a...

Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on #XR3. The network operator must configure #XR3 to force the 10.11.11....

Refer to the exhibit. After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships. Which statement about the configuration is true?

A network consultant is troubleshooting IS-IS instances to identify why a routing domains is having communication problems between the two instances. Which description of the possi...