300-615 Exam Questions

Refer to the exhibit. Two data centers are connected using a VXLAN EVPN Multi-Site fabric. VLAN 10 fails to be extended between the sites. Which configuration resolves the issue?

Refer to the exhibit. An engineer fails to perform a database merge between two Cisco MDS 9000 Series Switches named switch-1 and switch-2. Which set of commands resolves the issue...

Refer to the exhibit. A network engineer falls to boot a Cisco UCS blade from SAN. The data center uses Cisco UCS B-Series blades with the end-host mode configured on Cisco Fabric...

Refer to the exhibit. A network engineer fails to install applications in a newly deployed Guest Shell on a Cisco Nexus 9000 Series Switch. Which action in the Guest Shell resolves...

Refer to the exhibit. The web server fails to communicate with the storage array using the FCoE protocol. Which action resolves the issue?

A network engineer performs a remote firmware upgrade in a Cisco UCS environment. The I/O module on the secondary fabric interconnects becomes inaccessible during the upgrade. Ther...

Refer to the exhibit. An engineer is troubleshooting an issue with the Cisco ACI fabric discovery. During the Cisco APIC initialization, the infra VLAN was set to 4, and the TEP po...

Refer to the exhibit. The vFC interface is mapped to the port Ethernet 1/4 to which the FCoE- capable server is connected on the Cisco Nexus 9000 Series Switch. The Cisco Nexus swi...

Refer to the exhibit. The user that was created on the RADIUS server does not have read-only access to the Cisco UCS Manager GUL. Also, the role for the user has not been configure...

Refer to the exhibit. An engineer fails to load the Cisco Nexus 9000 Series Switch to configuration mode. Which command set resolves the issue?

Refer to the exhibit. An engineer implemented this fcdomain configuration on the MSD_1 and MDS_2 devices. However, after the engineer applies the configuration, this error is recei...

Refer to the exhibit. Which action must be taken to change the interface Eth1/3 on N9K-3 from suspended to up in the port channel?

Refer to the exhibit. The server appears as Unassociated Inside Cisco UCS Manager. The engineer performs a hard reboot and a reset, but the problem persists. Which action resolves...

Refer to the exhibit. The script must show the running configuration of interfaces eth1/1 to eth1/3. However, only a subset of interfaces is displayed when the script is run. Which...

Refer to the exhibit. A network engineer failed to upgrade the Cisco Nexus switch. Which action must be taken before the upgrade to resolve the issue?

Refer to the exhibit. A network configures a vPC between a pair of Cisco Nexus 9000 Series Switches. The LACP port channel has already been configured, but the port channel fails t...

Refer to the exhibit. Two Cisco Nexus 9000 Series Switches fail to establish OSPF neighborship. Which action resolves the issue?

Refer to the exhibit. Two Cisco ASA firewalls are configured in an active/standby cluster with eBGP in VXLAN fabric. The BGP routes are dropped and failed to install inside the BGP...

Refer to the exhibit. Two data center fabrics are configured based on EVPN Multi-Site technology. The EVPN Multi-Site virtual IP is moved to a down state. Which configuration actio...

Refer to the exhibit. An engineer noticed that after the initial Cisco APIC fabric discovery, the cluster is flapping between fully fit and degraded. Which connection must be estab...

Refer to the exhibit. The data centers are connected using the EVPN Multi-Site solution. However, VLAN 10 fails to extend to the secondary site with the message shown. Which action...

Refer to the exhibit. Two Cisco Nexus 9000 Series Switches fail to establish OSPF adjacency. Which configuration resolves the issue?

Refer to the exhibit. This configuration has been applied: Eth1/5 and Eth1/7 as uplink ports and belong to port-channel 100 Eth1/6 and Eth1/12 as uplink ports and belong to port-ch...

What does "line protocol is down" indicate in this output?

Refer to the exhibit. An engineer performs a firmware activation on the subordinate fabric interconnect A (FI A) during the manual upgrade process. After the fabric interconnect re...

Refer to the exhibit. The Eth 1/6 on the switch remains in a down state when the show interface eth1/6 command is entered. Which action resolves the problem?

An engineer connected two Cisco UCS I/O modules to fabric interconnect with four links. When link 4 between the IOM-1 and primary fabric interconnect went down, the connectivity th...

Refer to the exhibit. After a power outage, the application team reported that the Cisco UCS C- Series server is reachable only via the server's Cisco IMC and not via the operating...

Refer to the exhibit. The ESXi hosts fail to communicate with shared storage. Which type of port must interfaces eth2/2 and eth2/4 be configured as to resolve the issue?

Refer to the exhibit. The Fabric Interconnects connect the storage through the interface FC1/24, but the servers fail to boot the Linux operating system. Which port type must be us...

Refer to the exhibit. A Cisco UCS Series Server fails to boot from SAN, but all other devices in the network that are connected to different switches can boot from SAN. Which set o...

Refer to the exhibit. The Cisco UCS server that is connected to a Fibre Channel over Ethernet fails to connect to the storage device. The engineer verified that all cables are conn...

Refer to the exhibit. An administrator must use this script on the Cisco Nexus 9000 Series Switches environment. The applet that was created fails to run the script. Which command...

An engineer implemented the EEM applet shown below to send a syslog message when an interface goes down: event manager applet interface_down action 1.0 cli command "show interface...

Refer to the exhibit. A Cisco Nexus 9000 Series Switch must be configured to use only TACACS+ servers for default authentication. The engineer notices that the activity fails to ru...

A network engineer is attempting to integrate Cisco UCS Manager with Cisco UCS Central, but the integration fails. The engineer can ping Cisco UCS Central from Cisco UCS Manager. W...