Refer to the exhibit. An engineer is troubleshooting an issue with the Cisco ACI fabric discovery. During the Cisco APIC initialization, the infra VLAN was set to 4, and the TEP pool was configured…

The correct answer is A. Connect the Cisco APIC directly to Leaf-101. In a Cisco ACI fabric, the APIC (Application Policy Infrastructure Controller) must be directly connected to one of the leaf switches (e.g., Leaf-101) for proper fabric discovery and management. In the current topology, the APIC is connected to an L2 switch, which prevents it…

Network

Question

Refer to the exhibit. An engineer is troubleshooting an issue with the Cisco ACI fabric discovery. During the Cisco APIC initialization, the infra VLAN was set to 4, and the TEP pool was configured to use subnet 11.0.0.0/16. Which action resolves the issue?

Exhibits

Options

AConnect the Cisco APIC directly to Leaf-101.
BSet the Enable LLDP flag on Cisco APIC CIMC.
CConnect the Layer 2 switch to Leaf-101 and Leaf-102.
DSet the TEP pool to subnet 10.0.0.0/16.

How the community answered

(52 responses)

A
79% (41)
B
12% (6)
C
4% (2)
D
6% (3)

Explanation

In a Cisco ACI fabric, the APIC (Application Policy Infrastructure Controller) must be directly connected to one of the leaf switches (e.g., Leaf-101) for proper fabric discovery and management. In the current topology, the APIC is connected to an L2 switch, which prevents it from being properly discovered by the leaf switches. To resolve the issue, you should connect the Cisco APIC directly to Leaf-101 to ensure it can communicate correctly with the ACI fabric and participate in the discovery process.

Topics

#ACI fabric discovery#APIC initialization#infra VLAN#TEP pool

Community Discussion

No community discussion yet for this question.

Full 300-615 Practice