300-615 Exam Questions

An engineer troubleshoots a Cisco UCS B-Series environment and discovers that the status of the CNA is degraded in the CLI and the Cisco UCS Manager GUI. What should be done to res...

Refer to the exhibit. The scheduled Test job fails to be reconfigured with extra configuration on Cisco 9000 Series Switch. Which action resolves the issue?

Refer to the exhibit. The network administrator must use a scheduler to perform configuration backups every night. After completing the configuration, the administrator discovers t...

Refer to the exhibit. The servers experience intermittent connectivity issues in VLAN 10. Which action resolves the issue?

Refer to the exhibit. A client is reporting packet drops destined for the call recording server connected to Cisco Nexus 9000 Series Switch. Which action resolves the issue?

Refer to the exhibit. An engineer fails to implement VRRP on a Cisco Nexus 7000 Series Switch. Which action resolves the issue?

Refer to the exhibit. Server A and Server B experience inter-L2VN reachability issues. A BGP L2VPN session is up on both leaf switches and each leaf switch learns the host routes o...

Refer to the exhibit. An engineer deploys a Cisco MDS 9000 Series Switch in a SAN. N9K-1 fails to learn the target WWNs and the interface fc1/4 fails to operate. The engineer colle...

Refer to the exhibit. The LACP port channel fails between N9K-A and N9K-B. Which action resolves the issue?

Refer to the exhibit. A Cisco UCS system fails to access the storage array. Which two actions taken on both MDS switches resolve the issue? (Choose two.)

Refer to the exhibit. A newly deployed Cisco APIC1 fails to discover a Cisco Nexus Series Switch. Which configuration resolves the issue?

Refer to the exhibit. Server 1 and Server 2 are bare-metal Windows-based servers and can exchange ICMP PING messages. However, both servers fail to ping their default gateway. Whic...

An engineer is troubleshooting an unexpected blade-server reboot. One of the DIMMs is displayed inside Cisco UCS Manager as "degraded with correctable errors" but is still availabl...

Refer to the exhibit. An engineer applied a VXLAN tunnel between Cisco Nexus 5000 Series Switches to extend the Layer 2 segment between N7K-1 and N7K-2. However, there is still no...

Refer to the exhibit. An engineer is troubleshooting a VSAN membership issue on switch N9K_1 where vfc 13 is associated to VSAN 1 instead of VSAN 10. The Cisco UCS, N9K_2, and QoS...

Refer to the exhibit. The fault was raised after a port that belongs to a Cisco UCS chassis I/O module was connected to port 31 of the fabric interconnect. Which action resolves th...

Refer to the exhibit. Two Cisco Nexus Series Switches have been configured to form OSPF neighborship. Which action resolves the issue?

Refer to the exhibit. During an upgrade process of a pair of Cisco Nexus Series Switches with vPC implemented, the impact assessment generated the output "STP ISSU preupgrade check...

Refer to the exhibit. A network engineer fails to register a Cisco UCS B-Series server onto a Cisco Intersight device, which is deployed on premises using a virtual machine. Which...

An engineer deploys a Cisco fabric network based on spine-leaf architecture. Cisco DCNM has been integrated to support the automation of a virtual network service of a firewall. Af...

A network engineer must configure SNMP monitoring on the Cisco Nexus 5000 Series Switch. The engineer issues the SNMP-server user testuser enforcePriv command but receives this mes...

Refer to the exhibit. An engineer is configuring a VMM domain integration, but the operation fails to complete. Which two actions resolve the issue? (Choose two.)

Refer to the exhibit. The VXLAN communication fails between Server A and Server C. Server A and Server B can communicate, but Server C can only reach Server B and its default gatew...

Refer to the exhibit. A network engineer must implement an EEM script to generate SNMP traps when configuration mode is entered. After the configuration was applied, the configure...

Refer to the exhibit. An engineer configures OSPF adjacency between two Cisco Nexus Series Switches called Nexus-1 and Nexus-2. The OSPF adjacency fails to reach the FULL state. Wh...

Refer to the exhibit. A server is connected via vPC to a pair of Cisco Nexus 7000 Series Switches. Two interfaces must be operational. However, only one interface of the vPC primar...

Refer to the exhibit. The VXLAN fabric with BGP EVPN control plane experiences connectivity issues. The hosts in the initial deployed VLAN fail to communicate. The environment is c...

An engineer performs a Cisco B-Series firmware upgrade using a host firmware pack and AutoInstall server feature on an adapter. The adapter activation stops at the pending-next-boo...

Refer to the exhibit. A port channel on a Cisco Nexus 9000 Series Switch uplink experiences connectivity issues. Which configuration resolves the issue? \

Refer to the exhibit. An engineer must restore the connectivity issue between NEXUS-SW-3 and NEXUS-SW-4. The engineer can ping the physical and loopback interfaces used in the unde...

Refer to the exhibit. A Cisco VXLAN must use bidirectional PIM so that: - Spine2 is the active RP for multicast group 225.0.0.0/24. - Loopback 254 is used as a logical interface fo...

Refer to the exhibit. Two Cisco Nexus 9000 Series Switches fail to establish OSPF neighborship. Which action set resolves the issue?

Refer to the exhibit. A Cisco ACI fabric experiences a packet drop for high-priority signaling traffic. Which configuration protects high-priority queues from dropping?

Refer to the exhibit. The virtual machines running on Cisco UCS B-Series blades are experiencing performance issues that affect the network connectivity of the target application....

Refer to the exhibit. An engineer uses a REST API to map the interface selector with ports 1/1 to 1/20 to an interface profile. The script fails with a 400 response status code. Wh...

An engineer is troubleshooting a "Discovery Failed" error on a Cisco UCS C-Series server. The server is configured to be managed by the fabric interconnect directly. The engineer d...

A maintenance operation on power rail A caused a reboot of the servers in a Cisco UCS B-Series chassis. The Cisco UCS system has these attributes: - The system is equipped with fou...

Refer to the exhibit. An engineer analyzes the packet flow in a Cisco UCS domain that consists of Cisco UCS Fabric Interconnects. The engineer discovers that the virtual machine tr...

A Cisco UCS C125 M5 server is integrated with Cisco UCS Manager using direct connect mode. The adapter for the server is reported as "inoperable" inside Cisco UCS Manager. Which ac...

Refer to the exhibit. A network engineer configured Cisco Nexus 9000 Series Switches to allow the traffic between 172.16.10.10/24 to 172.18.3.100/24 to pass through the 100G-link,...

Refer to the exhibit. A Cisco UCS B-Series server 1/1 fails to communicate with server 1/2. Which action resolves the issue?

Refer to the exhibit. The receiver is listening to multicast group 239.200.0.1, but no packets are received for the requested multicast group. Which action resolves the issue?

Refer to the exhibit. A BGP VXLAN EVPN Is used in a data center. The Eth1/1 fails on SPINE-1, and traffic flow fails from Leaf-1 to the Leaf-2 VTEP over port channel 12 in VLAN 7....

An engineer must migrate a blade from UCS Domain A to UCS Domain B. The environment has these configurations: - B200 M5 contains a VIC 1440 that runs 4.0(4)B. - UCS Domain A is a C...

Refer to the exhibit. An engineer troubleshoots an issue involving where some Cisco MDS 9000 Series Switches fail to be discovered by other MDS switches in the VSAN. The engineer r...

An engineer must upgrade the firmware of the Cisco UCS B-Series servers that are managed by Cisco UCS Manager. The upgrade must start immediately without automatically restarting t...

An engineer is suspecting an issue where there is a mismatch between RIB and FIB. The same prefix is learned via different routing protocols. Based on this output, from which proto...

Refer to the exhibit. An engineer is configuring zone distribution on the Cisco Nexus 9000 Series Switch. After initial configuration, the zone distribution for VSAN 20 from core-2...

A Cisco ACI fabric consists of three tenants. User1 must have permission to manage only the PROD tenant. These configurations have already been completed: - The security domain TEN...

Refer to the exhibit. An Embedded Event Manager script is configured to override the link flap policy, but the script overrides all the events in the system policy. What must be ad...