Cisco
300-615 · Question #218
Refer to the exhibit. An engineer deploys a Cisco MDS 9000 Series Switch in a SAN. N9K-1 fails to learn the target WWNs and the interface fc1/4 fails to operate. The engineer collected this…
The correct answer is A. Set 0x000001 FCID on N9K-1 and reset interface fc1/4. See the full explanation below for the reasoning.
Question
Refer to the exhibit. An engineer deploys a Cisco MDS 9000 Series Switch in a SAN. N9K-1 fails to learn the target WWNs and the interface fc1/4 fails to operate. The engineer collected this information about the environment:
- MDS-A is configured as an NPV switch.
- The WWNs of the storage array are present in the FLOGI database of
MDS-A.
- Interfaces fc1/3 and fc1/4 on MDS-A and N9K-1 are enabled.
Which set of actions resolves the issue?
Exhibits
Options
- ASet 0x000001 FCID on N9K-1 and reset interface fc1/4.
- BOn N9K-1, define fc1/4 as a trunk port and F port mode.
- CConfigure F port on MDS-A fc1/3 and N9K-1 fc1/4.
- DAssign fc1/3 as NP port on MDS-A and F port on fc1/4 N9K-1.
How the community answered
(41 responses)- A78% (32)
- B7% (3)
- C12% (5)
- D2% (1)
Community Discussion
No community discussion yet for this question.