Cisco
300-615 · Question #240
Refer to the exhibit. An engineer must restore the connectivity issue between NEXUS-SW-3 and NEXUS-SW-4. The engineer can ping the physical and loopback interfaces used in the underlay from VTEP-1…
The correct answer is A. Change the VNI to VLAN mapping on the NEXUS-SW-2. See the full explanation below for the reasoning.
Question
Refer to the exhibit. An engineer must restore the connectivity issue between NEXUS-SW-3 and NEXUS-SW-4. The engineer can ping the physical and loopback interfaces used in the underlay from VTEP-1. However, communication between the SVIs in NEXUS-SW-3 and NEXUS-SW-4 fails. Which action resolves the issue?
Exhibits
Options
- AChange the VNI to VLAN mapping on the NEXUS-SW-2.
- BReload the NEXUS-SW-2 to enable the hardware Ethernet store-and-fwd-switching feature.
- CManually set the interface MTU to support jumbo frames on the NEXUS-SW-2.
- DReconfigure the VXLAN features in the VTEP switches on the NEXUS-SW-2.
How the community answered
(29 responses)- A83% (24)
- B3% (1)
- C10% (3)
- D3% (1)
Community Discussion
No community discussion yet for this question.