350-001 Exam Questions

A network is composed of several VRFs. It is required that VRF users VRF_A and VRF_B be able to route to and from VRF_C, which hosts shared services. However, traffic must not be a...

Which of these statements best describes the major difference between an IPv4-compatible tunnel and a 6to4 tunnel?

Which information is carried in an OSPFv3 intra-area-prefix LSA?

Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link?

You are using IPv6, and would like to configure EIGRPv3. Which three of these correctly describe how you can perform this configuration? (Choose three.)

Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses?

Unicast Reverse Path Forwarding can perform all of these actions except which one?

Which three of these statements about Dynamic Trunking Protocol are correct? (Choose three.)

You are designing your network to be able to use trunks. As part of this process you are comparing the ISL and 802.1Q encapsulation options. All of these statements about the two e...

What s the default stratum clock on a Cisco router, when you see the key word "master" configured on the NTP line?

Though many options are supported in EIGRPv6, select two options from the below list that are supported. Choose 2

During the IPv6 address resolution, a node sends a neighbor solicitation message in order to discover which of these?

Which one of these statements is true of OSPF type 5 LSAs?

Which OSPF LSA type does an ASBR use to originate a default route into an area?

Refer to the exhibit. Routers A and B are directly connected. Given the configuration, how many EIGRP routes will router B see in its routing table?

Refer to the exhibit. Routers A and B are directly connected and running EIGRP, but they are unable to form a neighbor relationship. What is the most likely cause?

Refer to the exhibit. Routers A and B are directly connected and running OSPF, but they are unable to form a neighbor relationship. What is the most likely cause?

Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution?

Two BGP peers connected through a routed firewall are unable to establish a peering relationship. What could be the most likely cause?

Which two of these steps are minimum requirements to configure OSPFv3 under IPv6? (Choose two.)

You add the following commands into a routed topology: router eigrp 1 variance 3 traffic-share min across-interfaces. Users now complain about voice quality in your VoIP system. Wh...

Refer to the exhibit. How would you get the 1.1.1.1 network into the OSPF database?

Refer to the exhibit. Router E learned about the PIM RP (designated as 7.7.7.7) from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and...

Refer to the exhibit. From the MAC addresses shown in the command output, to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch? (Choose two.)

Refer to the exhibit. Two ISPs have decided to use MSDP and configured routers X and Y (both are PIM RPs) as MSDP peers. In the domain of ISP B, PC A has sent an IGMP membership re...

You are about to migrate a customer network to use a VSS. Which of these statements is true about a VSS?

You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true?

The network administrator is trying to add Switch1 to the network, but the 802.1 Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configurati...

The core of a network has four routers connected in a square design with Gigabit Ethernet links using /30 subnets. The network is used to carry voice traffic and other applications...

Refer to the exhibit. BGP-4 routing to the Internet, in normal behavior, may create asymmetrical routing for different prefixes. The BGP routing table indicates that traffic should...

You replaced your Layer 3 switch, which is the default gateway of the end users. Many users cannot access anything now, including email, Internet, and other applications, although...

An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue, choose tw...

Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch?

Refer to the exhibit. Look at the command output. Assume that there is no other path, and the configuration is correct. What would be the consequences of this situation?

Refer to the exhibit. Look at the command output. What can you use to prevent this behavior?

When using IP SLA FTP operation, which two FTP modes are supported? (Choose two.)

If a certificate authority trustpoint is not configured when enabling HTTPS and the remote HTTPS server requires client authentication, connections to the secure HTTP client will f...

Refer to the exhibit. The Layer 2 network uses VTP to manage its VLAN database. A network designer created all VLANs on the VTP server (switch 1) and it has been advertised through...

A request arrived on your MPLS-vpn-bgp group. Due to a security breach, your customer is experiencing DoS attacks coming from specific subnets (200.0.10.0/24, 200.0.12.0/24). You h...

Half of your network uses RIPv2 and the other half runs OSPF. The networks do not communicate with each other. Which two of these factors describe the impact of activating EIGRP ov...

Your company is researching a new application that runs over IPv6, but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to ru...

Refer to exhibits 1 and 2. In exhibit 1, all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2, the network...

Refer to exhibits 1 and 2. A company uses a Metro Ethernet (Gigabit Ethernet) dedicated circuit to communicate between users (subnet B) and servers (subnet A) as shown in Exhibit 1...

Refer to the exhibit. Users from the Engineering VLAN complain that every time Business VLAN users have a network connectivity issue, the Engineering VLAN users usually have proble...

When running IP SLA, which application type should be used if you want to know round-trip delay, jitter, and packet loss for the full path?

Which option is true when calculating round-trip delay in IP SLA operations?

Refer to the exhibit. You are asked to enable redirection for a network optimization engine that will be connected directly to your company CPE. What is the correct configuration t...

Refer to the exhibit. A network engineer has connected a packet-capturing device to the common broadcast segment in this network, on which all the routers are configured to run OSP...

Refer to the exhibit. In this network, what will be the impact at R4 if the link between R1 and R2 fails?