You are using IPv6, and would like to configure EIGRPv3. Which three of these correctly describe how you can perform this configuration? (Choose three.)

Question

Options

• AEIGRP for IPv6 is directly configured on the interfaces over which it runs.
• BEIGRP for IPv6 is not configured on the interfaces over which it runs, but if a user uses
• CThere is a network statement configuration in EIGRP for IPv6, the same as for IPv4.
• DThere is no network statement configuration in EIGRP for IPv6.
• EWhen a user uses a passive-interface configuration, EIGRP for IPv6 does not need to be
• FWhen a user uses a non-passive-interface configuration, EIGRP for IPv6 does not need to be

• A
  86% (36)
• B
  2% (1)
• C
  10% (4)
• F
  2% (1)

Explanation

Restrictions for Implementing EIGRP for IPv6: This section lists ways in which EIGRP for IPv6 differs from EIGRP IPv4 as well as EIGRP for IPv6 restrictions. EIGRP for IPv6 is directly configured on the interfaces over which it runs. This feature allows EIGRP for IPv6 to be configured without the use of a global IPv6 address. There is no network statement in EIGRP for IPv6. In per-interface configuration at system startup, if EIGRP has been configured on an interface, then the EIGRP protocol may start running before any EIGRP router mode commands have been An EIGRP for IPv6 protocol instance requires a router ID before it can start running. ?EIGRP for IPv6 has a shutdown feature. The routing process should be in "no shutdown" mode in order to When a user uses passive-interface configuration, EIGRP for IPv6 does not need to be configured on the interface that is made passive. EIGRP for IPv6 provides route filtering using the distribute-list prefix-list command. Use of the routE.map command is not supported for route filtering with a distribute list. 09186a00805fc867.html

No community discussion yet for this question.