350-401 Exam Questions

Refer to the exhibit. An engineer is using XML in an application to send information to a RESTCONF-enabled device. After sending the request, the engineer gets this response messag...

Refer to the exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configura...

Refer to the exhibit. R1 is able to ping the R3 fa0/1 interface. Why do the extended pings fail?

How does SSO work with HSRP to minimize network disruptions?

Refer to the exhibit. Which command allows hosts that are connected to FastEthernet0/2 to access the Internet?

An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?

Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?

Which two characteristics define the Intent API provided by Cisco DNA Center? (Choose two.)

Refer to the exhibit. An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change...

Refer to the exhibit. What is the effect of the configuration?

How is a data modeling language used?

Which three methods does Cisco DNA Center use to discover devices? (Choose three.)

Refer to the exhibit. Which command when applied to the Atlanta router reduces type 3 LSA flooding into the backbone area and summarizes the inter-area routes on the Dallas router?

Refer to the exhibit. An engineer is installing a new pair of routers in a redundant configuration. Which protocol ensures that traffic is not disrupted in the event of a hardware...

An engineer must configure interface GigabitEthernet0/0 for VRRP group 10. When the router has the highest priority in the group, it must assume the master role. Which command set...

What are two reasons a company would choose a cloud deployment over an on-prem deployment? (Choose Two)

Refer to the exhibit. Which command must be applied to R2 for an OSPF neighborship to form?

Refer the exhibit. Which router is the designated router on the segment 192.168.0.0/24?

Which antenna type should be used for a site-to-site wireless connection?

Refer to the exhibit. Which two commands ensure that DSW1 becomes root bridge for VLAN 10 and 20?

Refer to the exhibit. Edge-01 is currently operational as the HSRP primary with priority 110. Which command on Edge-02 causes it to take over the forwarding role when Edge-01 is do...

What is the purpose of an RP in PIM?

You are configuring a controller that runs Cisco IOS XE by using the CLI. Which three configuration options are used for 802.11w Protected Management Frames? (Choose three.)

During deployment, a network engineer notices that voice traffic is not being tagged correctly as it traverses the network. Which COS to DSCP map must be modified to ensure that vo...

Refer to the exhibit. A wireless client is connecting to FlexAP1 which is currently working standalone mode. The AAA authentication processis returning the following AVPs: Tunnel-P...

Refer to the exhibit. An engineer is designing a guest portal on Cisco ISE using the default configuration. During the testing phase, the engineer receives a warning when displayin...

What would be the preferred way to implement a loopless switch network where there are 1500 defined VLANs and it is necessary to load the shared traffic through two main aggregatio...

What is the primary effect of the spanning-tree portfast command?

An engineer reviews a router's logs and discovers the following entry. What is the event's logging severity level? Router# *Jan 01 38:24:04.401: %LINK-3-UPDOWN: Interface GigabitEt...

When is it useful to disable split horizon on an EIGRP interface?

What does Call Admission Control require the client to send in order to reserve the bandwidth?

Which of the following multicast address ranges match the administratively scoped block? (Choose two.)

Which feature is supported by EIGRP but is not supported by OSPF?

Drag and Drop Question Drag and drop the DHCP messages that are exchanged between a client and an AP into the order they are exchanged on the right. Answer:

Drag and Drop Question Drag and drop the characteristics from the left onto the routing protocols they describe on the right. Answer:

Drag and Drop Question Drag and drop the threat defense solutions from the left onto their descriptions on the right. Answer:

Drag and Drop Question Drag and drop the characteristics from the left onto the infrastructure types on the right. Answer:

Refer to the exhibit. This is the configuration of the ASBR of area 110.Which option explains why the remote ABR should not translate the type 7 LSA for the prefix 192.168.0.0/16 i...

What is the function of an EIGRP sequence TLV packet?

What are two reasons to define static peers in EIGRP? (Choose two.)

Refer to the exhibit. R2 is mutually redistributing between EIGRP and BGP. Which configuration is necessary to enable R1 to see routes from R3?

What is the purpose of EIGRP summary leaking?

Refer to the exhibit. Which statement about this IP SLA is true?

Which IP SLA operation type is enhanced by the use of the IP SLAs Responder?

When PSK authentication is used on a WLAN, without the use of an ISE server, which of the following devices must be configured with the key string? (Choose two.)

One switch has EtherChannel configured as auto. What options on the other switch can be configured to establish an EtherChannel bundle?

Which two OSPF network type require the use of a DR and BDR? (Choose two)

Which BGP command advertises a summary route to prevent link-flap processing by downstream BGP routers?

Refer to the exhibit. While troubleshooting an issue with a blocked switch port, you find this error in the switch log. Which action should you take first to locate the problem?

What type of network device helps reduce the size of a broadcast domain?