350-501 Exam Questions
562 real 350-501 exam questions with expert-verified answers and explanations. Page 2 of 12.
- Question #53Networking
On Cisco IOS XR devices, which action improves failure reaction for Link OAM when Path Isolation with Ethernet Failure Detection is used?
Link OAMIOS XREthernet Failure DetectionFast Convergence - Question #54Networking
On the BGP Best Path Selection, when two external paths from different EBGP neighbors are received, the oldest path received can be the tie break to select the best path. Which Cis...
BGP Best Path SelectionBGP ConfigurationRouter IDEBGP - Question #55Services
Egress PE NAT is being used via a single centralized router to provide Internet access to L3VPN customers. Which description of the NAT operation is true?
NATL3VPNVRFEgress NAT - Question #56Networking
How much must the MTU be increased when configuring the 802.1q VLAN tag?
802.1qVLAN taggingMTUEthernet frame - Question #57Networking
Refer to the exhibit. Export statistics received do not include the BGP next hop. Which statement about the NetFlow export statistics is true?
NetFlowBGP Next-HopFlow Export ConfigurationNetwork Monitoring - Question #58Networking
Refer to the exhibit. Which three outcomes occur if the prefix list is added to the neighbor? (Choose three)
Prefix-listRoute FilteringBGPRouting Policy - Question #59MPLS and Segment Routing
Which statement about segment routing prefix segments is true?
Segment RoutingPrefix SIDSID Concepts - Question #60MPLS and Segment Routing
You are creating new Cisco MPLS TE tunnels. Which type of RSVP message does the headend router send to reserve bandwidth on the path to the tunnel's router?
MPLS TERSVP-TEPATH messageBandwidth Reservation - Question #64Networking
Refer to the exhibit. R1 is connected to two service providers and is under a DDoS attack. Which statement about this design is true if uRPF in strict mode is configured on both in...
uRPFNetwork SecurityDDoS MitigationRouting - Question #65MPLS and Segment Routing
A router is configured to perform MPLS LDP graceful restart. Which three steps are included when the RP sends an LDP initialization to a neighbor to establish an LDP session? (Choo...
MPLS LDP Graceful RestartLDP InitializationLDP TLVsLabel Distribution Protocol - Question #66Automation and Assurance
Refer to the exhibit. Which information is provided for traceback analysis when this configuration is applied?
Network MonitoringTraffic AnalysisNetFlowTroubleshooting - Question #67Services
Refer to the exhibit. Which statement describes the effect of this configuration?
class-mapQoSTraffic ClassificationMQC - Question #68MPLS and Segment Routing
Why do Cisco MPLS TE tunnels require a link-state routing protocol'?
MPLS TELink-State Routing ProtocolsTraffic EngineeringLSDB - Question #69Services
Which two steps must a service provider consider when adding multicast support to the existing MPLS L3VPN? (Choose two.)
MVPNDefault MDTBandwidth ManagementCore Routing State - Question #70Architecture
Which two features must be configured to perform AToM NSF? (Choose two)
Non-Stop Forwarding (NSF)Stateful Switchover (SSO)Graceful Restart (GR)MPLS High Availability - Question #71Architecture
A service provider network is currently divided into five IGP domains; four IS-IS domains and one OSPFv2 domain. Because of customer demand, it has been decided to implement Cisco...
MPLS TEBGP Link-StateMulti-domain NetworkingNetwork Controller Integration - Question #72Networking
You are enabling NSF for IS-IS. What are two advantages of Cisco NSF variation over IEFT NSF? (Choose two.)
NSFIS-ISNSRHigh Availability - Question #73Architecture
What is the main difference between the OSPF NSR and OSPF NSF mechanisms?
OSPFHigh AvailabilityNSRNSF - Question #74Networking
An operations engineer must implement IPv6 multicast leveraging the multicast group address FF70::/12. Which two Cisco IOS XE configurations are needed to accomplish this task? (Ch...
IPv6 MulticastPIMCisco IOS XENetwork Configuration - Question #78Networking
Refer to the exhibit. Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship bet...
BGPNeighbor RelationshipAS MismatchTroubleshooting - Question #79MPLS and Segment Routing
Which statement about the Cisco MPLS TE forwarding adjacency feature is true?
MPLS TEForwarding AdjacencyIGP IntegrationTraffic Engineering - Question #80MPLS and Segment Routing
Which additional feature does MPLS DiffServ tunneling support?
MPLS DiffServQoSPHBTunneling - Question #81Networking
You are writing an RPL scnpt to accept routes only from certain autonomous systems Consider this code. RP/0/RP0/CPU0:router(config-rpl)# if as-path in (ios-regex '.*77$') RP/0/RP0/...
RPLBGPAS-Path FilteringRegex - Question #82Networking
Refer to the exhibit. Which statement supports QPPB implementation?
QoSBGPQPPBTraffic Classification - Question #83Automation and Assurance
Refer to the exhibit. What does the REST API command do?
REST APIAutomationXMLNetwork Programmability - Question #84Networking
Why do packet loops occur during the configuration of BlDlR-PIM?
Multicast RoutingBIDIR-PIMPIM InteroperabilityPacket Looping - Question #85Automation and Assurance
Refer to the exhibit. This output is included at the end of an output that was provided by a device using NETCONF. What does the code show?
NETCONFRemote Procedure Call (RPC)Network AutomationXML - Question #86Architecture
Which statement describes the advantage of a Multi Layer control plane?
Multi-Layer Control PlaneNetwork ArchitectureMultivendor IntegrationControl Plane Benefits - Question #87Networking
Refer to the exhibit. Which statement about the status of the neighbor relationship between R1 and R2 is true?
IS-ISRouting Protocol AdjacencyIS-IS LevelsNetwork Troubleshooting - Question #88Networking
Refer to the exhibit. A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
BGPAS_PATHLocal ASRouting Protocols - Question #89Networking
Refer to the exhibit. Which condition must be met by the OSPF peer of router R1 before the two devices can establish communication?
OSPFAuthenticationRouting Protocols - Question #90MPLS and Segment Routing
Refer to the exhibit. Which statement about the neighbor statements for 192.168.1.1 is true?
BGP Label UnicastMPLS Label DistributionBGP send-label - Question #91Automation and Assurance
Which regular expression query modifier function indicates the start of a string?
Regular ExpressionsString matchingPattern matchingRegex metacharacters - Question #95Automation and Assurance
Which statement about Network Services Orchestrator (NSO) is true?
Cisco NSOYANGNetwork AutomationOrchestration - Question #96Networking
Which task must be performed first to Implement BFD in an IS-IS environment?
BFDIS-ISInterface ConfigurationRouting Protocol Integration - Question #97Networking
An engineer working for telecommunication company with an employee id: 3715 15 021 needs to secure the LAN network using a prefix list. Which best practice should the engineer foll...
Prefix ListsNetwork FilteringSequence NumbersConfiguration Best Practices - Question #98MPLS and Segment Routing
Refer to the exhibit. A network operator working for service provider with an employee id 3715 15:021 applied this configuration to a router. Which additional step should the engin...
MPLS LDPMPLS ConfigurationInterface Configuration - Question #99MPLS and Segment Routing
Refer to the exhibit. Which statement about this configuration is true?
MPLS Traffic EngineeringSegment RoutingSR-TE Tunnel ConfigurationHead-End Router - Question #100Networking
Refer to the exhibit. An engineer wants to authenticate the OSPF neighbor between PEA and PE- B using MD5. Which command on PE-B successfully completes the configuration?
OSPF AuthenticationMD5 SecurityRouting Protocol ConfigurationService Provider Routing - Question #101Networking
Refer to the exhibit. It the NetFlow configuration is updated to version 9, which additional piece of information can be reported?
NetFlowNetFlow v9Flow monitoringBGP AS - Question #102MPLS and Segment Routing
You are testing the capabilities of MPLS OAM ping. Which statement is true?
MPLS OAMLSP PingMPLS TroubleshootingMPLS Operations - Question #103Networking
Refer to the exhibit. R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically Based on this output, which statement is true?
IS-ISRouting Protocol AuthenticationIS-IS Levels - Question #104Networking
Which BGP attribute is used first when determining the best path?
BGPBGP Best PathBGP AttributesWeight - Question #105Networking
While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command. After you issue this command, which BGP packets does the PE accept...
BGPTTL SecurityNetwork Security - Question #106Automation and Assurance
Refer to the exhibit. This configuration is being applied on an IOS XR router. Which statement about this configuration is true?
Model-Driven TelemetryStreaming TelemetryIOS XRTelemetry Configuration - Question #107MPLS and Segment Routing
Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?
LDP Graceful RestartMPLSLDP Session ProtectionLDP Neighbor States - Question #108MPLS and Segment Routing
Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1...
LDPMPLSNeighbor AdjacencyInterface Configuration - Question #109Automation and Assurance
Which two uses of the YANG data modeling language are true? (Choose two)
YANGData ModelingNetwork AutomationNETCONF - Question #110Services
How can shared services in an MPLS Layer 3 VPN provide Internet access to the customers of a central service provider?
MPLS L3 VPNRoute TargetsShared ServicesInternet Access - Question #111Networking
Which statement about VRF Lite is true?
VRF LiteVirtual Routing and ForwardingMPLS Contrast