VDCD510 Exam Questions

You are working on a virtual guest design for the deployment of a critical business application. The software vendor has provided you with some projected workloads. One of the proj...

The VMware hot add and hot plug functionality is most useful for a(n) __________ scaling approach.

Application performance test cases are most accurate if based on ____________.

An installation guide should contain _____________. (Choose two)

An implementation plan should contain _____________.

You are a VMware consultant for a large enterprise running VMware vSphere 4.1. You are reviewing the upgrade documentation created to take the company to version 5.X of the softwar...

Which of the following type of discovery methods is least likely to impact the platform it is discovering?

A component relationship diagram can be used to establish the order of component change or impact analysis.

A validation plan is a set of processes which prove that a project or a function of a platform has been configured correctly and behaves as designed.

A validation plan can be used to gather further requirements.

A platform validation plan is primarily concerned with guest VM settings and application delivery rather than VMware platform functionality.

For effective VMware platform validation to take place, that platform should be _____________.

A good design ______________. (Choose two)

Vendor support may prevent an application from being virtualized.

Which of the following are the infrastructure qualities?

You are VMware designer working at a company where a new business application is being rolled out. The SLA requirements are RTO of 2 hours and RPO of 10 minutes. During a project t...

You are a VMware architect working at a company where a new business application is being rolled out. Based on a conversation with the business, you establish that the RTO requirem...

You are a VMware architect working at a company where a business application is being rolled out. Based on conversations with the business, you establish that the RTO requirement i...

You are a VMware designer working on virtualizing a business application. The SLA specifies that the RTO requirement is 4 hours, and the RPO requirement is 9 hours. After months of...

You are VMware architect working at a large enterprise where a new VMware platform is being installed. Based on conversations with the business, you establish that the RTO requirem...

The recovery time objective is the point in time to which a system needs to be restored following a failure.

The recovery point objective is the point in time to which a system needs to be restored following a failure.

When considering incorporating redundancy into design, which of the following should be considered?

Which of the following factors should influence the decision of whether to virtualize an application? (Choose three)

Which of the following describes the anticipated time until a solution component may fail?

A well-thought-out request for change document contains __________. (Choose three)

You are a VMware platform designer at a large service provider reviewing a network design. Two of the requirements are as follows: R001: All traffic must be encrypted or separated....

The use of software-based iSCSI storage allows encryption to be used in logical designs.

You are reviewing a vSphere platform design. The system is planning to use a virtual vCenter server. Which of the following is not true if the vCenter fails when using this design?

You are reviewing a vSphere platform design. The system is planning to use a virtual vCenter server. Which of the following is true if the vCenter fails when using this design?

Which of the following is a logical boundary for vMotion?

You have been asked to design a system with the following VMware functionality enabled: R001: VMware HA must be functional. R002: VMware SRM can be used between two sites for DR pr...

When using VMware HA, the larger the consolidation ratio, the smaller the potential impact to the business in the event of a VMware HA event.

In a platform with two vCenters configured with Linked mode, one vCenter can be configured using the VCSA.

When considering scalability, the VCSA is not as effective as the vCenter installed on a Windows platform.

When deploying a vCenter solution for a vSphere design, continuous uptime is stated as a requirement. The use of vCenter heartbeat has been agreed upon and budgeted. The design con...

You are a platform designer reviewing a colleague's design. Based on vSphere 5, the platform is designed to be scalable and provide continuous availability of the vCenter. The prop...

Which of the following is not a basic component of a good design?

Which component of a good design is described as the quantitative statement of what the project does and does not include?

A nonfunctional requirement _____________.

A functional requirement ____________.

A ____________ is an iterative process used to define a technical solution.

A ______________ design requires IP addresses and specific hardware selections.

Which design is created first?

A logical design includes basic subsystems that the design will use and data flow directions, but it does not include specific hardware or settings details.

A nonfunctional requirement is similar to a(n) _______.

Best practices should always be followed.

Best practices can change over time.

Which of the following is not a reason to use virtualization?

Which of the following tools can be used to gather information for a current state analysis?