D-SNC-DY-00 Exam Questions
46 real D-SNC-DY-00 exam questions with expert-verified answers and explanations. Page 1 of 1.
- Question #1
How many ports are in each port-group on the S5200 series switches?
- Question #2
Refer to the exhibit. What is the purpose of the static route?
- Question #3
An administrator for a service provider uses this command on a switch: What is the result of running the command?
- Question #4
An administrator issues The ztp enable and show ztp status commands. What two objectives are they trying to accomplish?
- Question #5
What is an iBGP neighbor relationship?
- Question #6
A deployment requires routing and dynamic access control lists. What bundle must be used for this deployment?
- Question #7
Refer to the exhibit. The router ID has not been manually configured. What router ID is used for Switch 3?
- Question #8
Refer to the exhibit. Eth 1/1 of SONiC-1 and Eth1/56 of SONiC-2 should be a routed link connecting the two Enterprise SONiC switches. No traffic is passing between them. What is th...
- Question #9
Which two additional Q-in-Q VLAN tunnel configuration steps must be followed if the provider network uses a VXLAN overlay?
- Question #10
What does show interface breakout port slot/slot command display?
- Question #11
Refer to the exhibit. What type of route is shown?
- Question #13
What is a correct use-case scenario for ZTP in Enterprise SONiC?
- Question #14
What is the purpose of the write erase boot command option?
- Question #15
What is the impact of entering the qos-mode uniform command on a VTEP interface?
- Question #16
What interface must be selected when configuring the management port from within the MF-CLI environment?
- Question #17
Refer to the exhibits.PC1 has a valid address on the 192.168.10.0 network, and PC2 has a valid address on the 192.168.20.0 network. What happens when a ping command is issued betwe...
- Question #26
Which three items are in the output of the show mclag brief command when using Enterprise SONiC?
- Question #27
An administrator wants to manually install Enterprise SONiC on a switch without NOS installed. Where should the administrator initialize the installation process?
- Question #28
Which are two characteristics of the route redistribution feature in Enterprise SONiC?
- Question #29
Refer to the exhibit. What can be determined from this show command?
- Question #30
How many port channels can be assigned to a single port?
- Question #31
Which two elements must be included in the show mclag interface x x command?
- Question #32
Which three actions are required to route traffic sourced from voice servers to a dedicated Internet link?
- Question #33
An administrator is installing Enterprise SONIC in ONIE from an HTTP server. On which interface should the administrator configure the IP?
- Question #34
What are three characteristics of VLAN translation?
- Question #35
Refer to the exhibit. Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?
- Question #36
Match the following VXLAN terms with their descriptions: VXLAN Term VXLAN Tunnel Endpoint (VTEP) MAC-in-UDP Asymmetric IRB Symmetric IRB Description
- Question #37
Refer to the exhibit. What can be determined from this show command?
- Question #38
Which of the following can be used to classify traffic for QoS in SONiC?
- Question #39
What factors should be considered when selecting an Enterprise SONiC bundle?
- Question #40
How many times must BGP be configured when running symmetric IRB with two VFRs?
- Question #41
What does the show vian command display?
- Question #42
Which two things does the no vrrp 100 address-family ipv6 command delete?
- Question #43
An administrator obtains the following CLI output: How much time does the local system take to detect remote failures without receiving packets?
- Question #44
Which two elements are configured when RoCE is enabled?
- Question #45
What are the supported modes for the QSFP28 ports on an S5248F?
- Question #46
What are two characteristics of route maps in Enterprise SONIC?
- Question #47
Which network devices route unencapsulated user traffic in a symmetric IRB overlay network?
- Question #48
Refer to the exhibit. What is the primary VRRP router for VRRP group 10?
- Question #49
When installing SONiC using the ONIE manual method, you must first __________ the ONIE environment before loading the SONiC installation image.
- Question #50
On which interfaces should traffic policing be applied?
- Question #51
What two actions occur when applying dynamic port breakout on an interface?
- Question #52
What two methods can be used to upgrade or downgrade Enterprise SONiC?
- Question #53
Refer to the exhibit. The route distinguisher was autogenerated. Which VLAN is mapped to VNI410?
- Question #54
Enterprise SONiC Switch 1 and Switch 2 are part of a symmetric VXLAN fabric in a data center environment. Switch 1 has learned MAC addresses from its local VLANs. What role does BG...
- Question #55
Which protocol is used to perform an automated installation of Enterprise SONiC?