Refer to the exhibit. What can be determined from this show command?

Question

Exhibits

Options

• AVTEP1 only accepts traffic from a 4.4.4.4 source address.
• BVxLAN QoS has been enabled on the remote VTEP.
• CVPN has been enabled on the local device.
• DInterface loopback 33 has been configured with 4.4.4.4 as an IP address.

• A
  8% (3)
• B
  5% (2)
• C
  3% (1)
• D
  85% (34)

Explanation

Option D is correct because the show command output (likely show nve interface or a similar VxLAN command) displays the source interface for the local VTEP as Loopback 33 and its associated IP address as 4.4.4.4. In VxLAN, the local VTEP always uses a loopback interface as its tunnel source, so the IP shown belongs directly to that loopback.

Why the distractors are wrong:

• A is wrong because 4.4.4.4 is the local source address of this device, not a traffic filter or ACL restricting inbound sources from remote VTEPs.
• B is wrong because QoS settings appear in QoS-specific show commands, not in a VxLAN/NVE interface status output - and an IP address tells us nothing about QoS.
• C is wrong because VxLAN is an overlay encapsulation technology, not a VPN service; VPN enablement would appear in a completely different show command context.

Memory tip: Think of the loopback as the VTEP's "home address" - whatever IP is assigned to that loopback is the VTEP IP. If a show command displays a source interface (e.g., Loopback 33) alongside an IP (e.g., 4.4.4.4), the IP lives on that interface - no filtering, no QoS, no VPN implied.

No community discussion yet for this question.