350-501 Exam Questions

Refer to the exhibit. A network administrator is implementing IGMP to enable multicast feed transmission to the receiver. Which configuration must the administrator deploy on GW1 t...

A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements: - Management protocols must be m...

Refer To the exhibit. Which BGP attribute should be manipulated to have CE1 use PE1 as the primary path to the Internet?

Refer to the exhibit. A network operator working for a telecommunication company with an employee 3994:37:650 is implementing a cisco Unified MPLS solution. What is the effect of t...

An engineer must extend Layer 2 Between two campus sites connected through an MPLS backbone that encapsulates Layer 2 and Layer 3 data. Which action must the engineer perform on th...

The engineering team at a large ISP has been alerted a customer network is experiencing high traffic congestion. After a discussion between the ISP and technical personnel at the c...

An engineer is implementing IGMP with SSM on a multicampus network that supports video streaming. Which task must the engineer perform as part of the process?

Refer to the exhibit. An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to...

Refer to the exhibit. An engineer has started to configure a router for secure remote access as shown. All users who require network access need to be authenticated by the SSH Prot...

Refer to the exhibit. A network operator has two IPv4 and IPv6 dual-stacked network on each side of the IPv4 core network. The operator must be able to provide connectivity between...

Which additional configuration is required for NetFlow to provide traceback information?

What is a characteristic of prefix segment identifier?

An engineer working for a private service provider with employee id: 3994 37 650 is configuring a Cisco device to redistribute OSPF into BGP. Which task enables the device to filte...

A network engineer is configuring a newly installed PE router at the regional gateway location. The new PE router must use MPLS core routing protocols with the existing P router, a...

What do Chef and Puppet have in common?

Refer to the exhibit. CE1 and CE2 require connectivity to the internet through the ISP connected to PE3. What should an engineer configure to complete this task?

Refer to the exhibit. A Cisco engineer is implementing gRPC dial-out on an ASR. Receiver 192.168 1.1 will be assigned one of the subscriptions, and it will manage the ASR. Which co...

Refer to the exhibit. Which show command shows statistics for the control plane policy and is used to troubleshoot?

A network engineer is configuring RIP as the routing protocol between multiple PEs and CEs. The engineer must avoid advertising the same routes back to their sources. Which action...

The network-engineering team of a service provider is integrating several recently acquired networks into a more scalable common Unified MPLS architecture. The new network architec...

Refer to the exhibit. If RC is a stub router, which entry must be injected so that it will send traffic outside the OSPF domain?

Refer to the exhibit. Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 networks via BGP and advertise them into OSPF area 0. An engineer has noticed that the...

An engineer is implementing a route map to support redistribution within BGP. The route map must be configured to permit all unmatched routes. Which action must the engineer perfor...

Refer to the exhibit. A network operator is attempting to configure an IS-IS adjacency between two routers, but the adjacency cannot be established. To troubleshoot the problem, th...

An engineer is implementing MPLS to monitor within the MPLS domain. Which must the engineer perform to prevent packets from being forwarded beyond the service provider domain when...

An engineer is implementing a Cisco MPLS TE tunnel to improve the streaming experience for the clients of a video-on-demand server. Which action must the engineer perform to config...

What occurs when a high bandwidth multicast stream is sent over an MVPN using Cisco hardware?

How do intent APIs make it easier for network engineers to deploy and manage networks?

Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?

Refer to Exhibit. A network engineer is trying to retrieve SNMP MIBs with RESTCONF on the Cisco switch but fails. End-to-end routing is in place. Which configuration must the engin...

Which feature describes the adjacency SID?

Refer the exhibit. Users on a network connected to router R3 report slow speeds when they connect to the server connected to R2. After analyzing traffic on the network, a network e...

Refer to the exhibit. The network team must implement MPLS LDP session protection with two requirements: - Session protection is provided for core loopback IP addresses only. - The...

Refer to the exhibit. An engineer configured R6 as the headend LSR of an RSVP-TE LSP to router XR2, with the dynamic path signaled as R6-R2-R5-XR2. and set the OSPF cost of all lin...

Refer to the exhibit. ISP ASN 65100 provides Internet services to router CE-1 and receives customer prefix 198.18.18.0/24 via eBGP. An administrator for the ISP is now provisioning...

A customer has requested that the service provider use a Cisco MPLS TE tunnel to force the E- line service to take a specific route. What is used to send the traffic over the tunne...

An engineer must apply an 802.1ad-compliant configuration to a new switchport with these requirements: - The switchport must tag all traffic when it enters the port. - The switchpo...

Refer to the exhibit. A network engineer is in the process of implementing IS -IS Area 1 and Area 2 on this network to segregate traffic between different segments of the network....

A network engineer must configure a router for Flexible NetFlow IPFIX export. The IP address of the destination server is 172.17.12.1. The source address must be set to the Loopbac...

Which action does the ingress VTEP perform on traffic between EVPN VXLAN overlays?

Refer to the exhibit. An organization s network recently experienced several significant outages due to device failures. The network administrator just moved the network devices to...

A network administrator is planning a new network with a segment-routing architecture using a distributed control plane. How is routing information distributed on such a network?

When Cisco lOS XE REST API uses HTTP request methods what is the purpose of a PUT request?

Refer to the exhibit. An engineer started to configure a router for OSPF. Which configuration must the engineer perform on the router without changing any interface configuration s...

Refer to the exhibit. A network engineer must meet these requirements to provide a connects, solution: - The customer connected to Area 2 needs to access the application in Area 1...

Refer to the exhibit. EIGRP is running across the core to exchange internal routes, and each router maintains iBGP adjacency with the other routers on the network. An operator has...

A network operator working for a telecommunication company with an employee Id: 4065 96080 it trying to implement BFD configuration on an existing network of Cisco devices Which ta...

A network architect decides to expand the scope of the multicast deployment within the company network. The network is already using PIM-SM with a static RP that supports a high-ba...

Refer to the exhibit. The USER that is connecting an application on an Internet connection in AS 100 is facing these issues: - The USER lost the connection to the application durin...

After a series of unexpected device failures on the network, a Cisco engineer is deploying NSF on the network devices so that packets continue to be forwarded during switchovers. T...