350-501 Exam Questions

What are two characteristics of MPLS TE turrets? (Choose two)

Refer to the exhibit. A network operator needs to shut down interface Gi0/0/0/2 for maintenance. What occurs to the interface states of Gi0/0/0/0 and Gi0/0/0/1?

A customer requests that sites are connected over an MPLS backbone using the MPLS AToM service. However, the network engineer advises that the MPLS L3VPN service may be better for...

An engineer needs to implement QOS mechanism on customer's network as some applications going over the internet are slower than others. Which two actions must the engineer perform...

Refer to the exhibit. ASN 64501 currently reaches the networks under the 10.0.0.0/8 prefix via the North_B router, which is a slow backup link. The administrator of ASN 64502 wants...

A network engineer is configuring Flexible NetFlow and enters these commands. What are two results of implementing this feature instead of traditional NetFlow? (Choose two.)

Refer to the exhibit. An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adja...

Refer to me exhibit. A network operator recently configured BGP FlowSpec for me internal IT network. What will be inferred from the configuration deployed on me network?

What are two factors to consider when implementing NSR High Availability on an MPLS PE router? (Choose two.)

Which statement about TLS is accurate when using RESTCONF to write configurations on network devices'?

Refer to the exhibit. An engineer is updating this network to meet these conditions: - Area 10 will receive inter-area routes and support mutual redistribution of external routes w...

Refer to the exhibit. While troubleshooting a connectivity issue on router R2, a network engineer with an employee id:3876.13.497 notices that although it detects three OSPF links...

What is the characteristic of the Tl-LFA?

Refer to the exhibit. A network engineer is deploying SNMP configuration on client's routers. Encrypted authentication must be included on router 1 to provide security and protect...

The administrator of a small company network notices that intermittent network issues occasionally cause inbound notifications to its SNMP servers to be lost. Which configuration m...

Refer to the exhibit. A network operator must configure CSR1 interfaces GigabitEthernet2 and GigabitEthernet3 to rewrite VLAN tags 12 and 21 for traffic between R1 and R2, respecti...

Which two actions describe ISP delegation to PCE servers? (Choose two)

Refer to the exhibit. An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engin...

A service provider is using QoS to manage customer traffic over the MPLS backbone. Which three statements about the behavior of each MPLS QoS mode based on QoS policy in the servic...

A network engineer is tasked with supporting traffic discrimination over MPLS traffic engineering tunnels. To allocate restricted bandwidth to a certain type of traffic with no QoS...

Which type of attack is a protocol attack?

A company needs to improve the use of the network resources that is used to deploy internet access service to customers on separate backbone and internet access network. Which two...

Refer to the exhibit. To protect in-band management access to CPE-R7, an engineer wants to allow only SSH management and provisioning traffic from management network 192.168.0.0/16...

An engineer implemented LDP protocol on the ISP network. The engineer must ensure that there are no packet loss issues when IGP and LDP protocols are not synchronized. Which config...

What is the function of the FEC filed within the OTN signal structure?

Which two routing protocols support Cisco MPLS TE Tunnels? (Choose two.)

Which protocol is used for communication between the PCE and PCC?

Refer to the exhibit. An engineer is reviewing the BGP configuration. Which router must be advertised to 10.10.10.1?

Refer to the exhibit. AN engineer is configuring segment routing on an ISP to simplify traffic engineering and management across network domains. What should the engineer do to com...

How is a telemetry session established for data analytics?

Refer to the exhibit. An engineer is configuring IS-IS on ISP network. Which IS-IS configuration must an engineer implement on router AGG1 so that it establishes connectivity to ro...

Which two PHY modes are available to implement an IOS XR Gigabit Ethernet interface? (Choose two.)

Refer to the exhibit. A network administrator implemented MPLS LDP changes on PE-A LSR device. The engineer must ensure there are no LDP peer are fully operational. Which LDP featu...

After implement MPLS protocol for multiple VRFs on a single Cisco device, the engineer notices all VRFs on the router still do to not LDP session protection feature enabled. When c...

Refer to the exhibit. An engineer is securing a customer's network. Which command completes this configuration and the engineer must use to prevent a DoS attack?

Refer lo the exhibit. An engineer working for private Service Provider with employee id: 3948:11:613 is configuring the BGPsec framework. Which two conditions must the engineer tak...

Which characteristic describes prefix segment identifier?

Refer to the exhibit. What does the REST API command do?

Refer to the exhibit. An engineer configured BGP summarization on a customer's network. Which route is advertised to BGP peers?

Refer to the exhibit. An engineer is trying to implement BGP configuration on a router. Which configuration error prevents the ASBR from establishing a BGP neighborship to a direct...

Refer to the exhibit. An engineer implemented OSPF neighbor relationship on an IOS device. Which configuration must be applied to get the OR/BOR election removed from interfaces ru...

An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?

After a possible security breach, the network administrator of an ISP must verify the times that several different users logged into the network. Which command must the administrat...

Refer to the exhibit. Router 1 and router 2 are running OSPF Area 0. The router logs on both routers show that the LDP link has flapped. Which configuration must the engineer apply...

Refer to the exhibit. An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound...

Refer to the exhibit. An engineer implemented this configuration. What is the status of the neighbor relationship between R1 and R2?

A network operator needs to implement PIM-SSM multicast configuration on customer's network so that users in different domains are able to access and stream live traffic. Which two...

Refer to the exhibit. What does this REST API script configure?

What is the role of NSO in network automation?

Refer to the exhibit. A network engineer notices that router R2 is failing to install network 172.16.33.1/32 in the routing table. Which configuration must the engineer apply to R2...