CTS Exam Questions

A remote monitoring system's PRIMARY benefit is that it

During the needs analysis stage, it is MOST IMPORTANT to determine the client's

During a site survey, a sound pressure level (SPL) meter can be used for measuring

Which addressing scheme is used to define a fixed, routable IPv4 address that is locally assigned?

This image shows the workings of which type of microphone?

System performance verification occurs when the system is

When comparing two products and trying to decide which product to use, what is the FIRST thing that should be reviewed?

The description and pricing for an AV solution is submitted during which phase of an AV project?

In order to run three cables inside a conduit, what is the maximum percentage of a conduit's internal cross-sectional area to be considered?

A client with an open concept office space has stated a concern regarding speech privacy for workers. A possible solution for this issue is a(n)

When choosing an amplifier for a 70 V system, what amplifier output would be the BEST option for a space with 12 speakers, each tapped to 30 W?

Which requirement supersedes others when planning an AV project for a client?

For ceiling speakers with a 90?effective coverage angle, a ceiling height of 3 m (10 ft), and an ear height of 1.2 m (4 ft), the spacing for a 50% coverage or edge-to-center layout...

A typical speech reinforcement system which is broken down into zones, with each zone corresponding to its own set of microphones, power amplifiers, and loudspeakers is known as:

Which agreement typically includes installation materials and workmanship against failure for a stipulated period after the installation is complete?

When using an IR-based assistive listening system, where MUST the transmitter be located?

During system verification, an issue has been noted where the microphone becomes very quiet when any laptop audio is played. What should be reviewed in the audio DSP?

What is defined by a work breakdown structure (WBS)?

A crucial part of the bid (tender) process is the request for clarification. At what point in the bid (tender) process would a potential bidder submit a request for clarification?

Before designing a Wi-Fi network-controlled system, what should the system integrator verify with the final customer?

The purpose of the system performance verification process is to:

Projectors utilizing laser phosphor technology might be favored for installation in inaccessible locations because:

While replacing a lamp in a client's LCD projector, it is important to:

When preparing to fly a projector, a technician finds that two of the six mounting bolts for the flyware/mount are stripped. What SHOULD the technician do?

What device should be used to send a single video signal to several monitors?

If the nominal light output of a projector was measured at 5000 ANSI lumens using an f/1.4 lens, what would happen if the lens was changed to an f/2.8 large zoom?

What is the MAIN difference between OLED displays and LCD displays?

When running audio in an enclosed booth, what feature is MOST important for the studio monitors used by the sound engineer?

According to AVIXA's AV Performance Verification standard, at what point should the loudspeaker transformer tap setting be verified?

An AV technician has been called to a lecture hall where the presenter complains of a loud squealing noise that makes their presentation inaudible. What is the BEST strategy to add...

Determining the expectations of the end users of a presentation space is called a(n):

A client is reporting picture drop-outs in an HDBaseT installation. What could be a possible cause?

Signal flow on a schematic is conventionally shown in which direction?

In the initial stage of determining AV equipment for an installation, the AV team gathers information PRIMARILY to:

A client wants to replace an older projector with a flat-panel 240 in (610 cm) diagonal display. The client has complained about the cost of replacement lamps for the existing proj...

The functionality of an audio system is often reduced to what three easily understood concepts?

During the initial visit with a new client, which one of the following items should always be ascertained?

A client wants to install new ceiling microphones to an existing system. Which trade does the technician need to coordinate with for the microphone placement?

Which of the following is the correct group of signal cables that can be cabled within one side of a rack while considering the signal separation in order to avoid electromagnetic...

A new construction is underway and the walls are framed but not yet drywalled. What is the MOST ideal to check at this time?

A full range reinforcement system will TYPICALLY have a frequency response of:

When evaluating site conditions for an AV project that requires a free-standing rack that is 49 RU or taller, the condition that will force assembly on site instead of building the...

What results from connecting a computer to the network using DHCP?

When a presenter is using a headworn wireless microphone, the sound technician notices a great deal of plosives and breath noise. To correct this problem, the technician should:

A change order (variation) is best defined as a:

When addressing system functionality with a client, an integrator should:

According to AVIXA's Projected Image System Contrast Ratio standard, what is the minimum contrast ratio for a projected image?

When conducting an analysis of the customer's needs, the integrator should:

Microphone signal levels are typically measured in:

Assessing the skill level of the end user: