350-001 Exam Questions

What is the flooding scope of an OSPFv3 LSA, if the value of the S2 bit is set to 1 and the S1 bit is set to 0?

How will EIGRPv6 react if there is an IPv6 subnet mask mismatch between the Global Unicast addresses on a point-to-point link?

Which two tunneling techniques support IPv6 multicasting? (Choose two.)

Which two OSPF LSA types are new in OSPF version 3? (Choose two.)

Refer to the exhibit. How will traffic be split between the routers, assuming that there are many hosts on this subnet?

Refer to the exhibit. A packet from RTD with destination RTG, is reaching RTB. What is the path this packet will take from RTB to reach RTG?

Refer to the exhibit. Which path is selected as best path?

What action will a BGP route reflector take when it receives a prefix marked with the community attribute NO ADVERTISE from a client peer?

Refer to the exhibit. R1 is not learning about the 172.16.10.0 subnet from the BGP neighbor R2 (209.165.202.130). What can be done so that R1 will learn about this network?

Refer to the exhibit. After a link flap in the network, which two EIGRP neighbors will not be queried for alternative paths? (Choose two.)

Refer to the exhibit. Why is AS 65333 in parentheses?

Refer to the exhibit. Which action would make the router the active VRRP router?

Refer to the Exhibit. The displayed QoS configuration has been configured on a router. IPv6 is being implemented on the router, and it is required to convert the QoS policy to supp...

Voice quality is bad due to high delay and jitter on a link. Which two actions will improve the quality of voice calls? (Choose two.)

Refer to the exhibit. On what will the config class-map VOICE match?

Refer to the exhibit. Assuming that the routing protocol for this network is EIGRP, if the link between R1 and R3 failed, what would R4 receive from R3?

Which three statements accurately describe a link-state routing protocol? (Choose three.)

Refer to the exhibit. What is true about the configuration in this exhibit?

Refer to the exhibit. Users that are connected to switch SWD are complaining about slow performance when they are doing large file transfers from a server connected to switch SWB....

Refer to the exhibit. Clients in VLAN 10 complain that they cannot access network resources and the Internet. When you try to ping the default gateway from one of the affected clie...

While you are troubleshooting network performance issues, you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the...

Your network is suffering from regular outages. After troubleshooting, you learn that the transmit lead of a fiber uplink was damaged. Which two features can prevent the same issue...

Refer to the exhibit. You are trying to police down to 100 Mb/s. While testing, you notice that you rarely exceed 70-80 Mb/s. What do you need to change in your MQC configuration t...

Which feature would prevent guest users from gaining network access by unplugging an IP phone and connecting a laptop computer?

After applying a new ACL on a device, its CPU utilization rose significantly and many messages starting with "%SEC-6-IPACCESSLOG" appeared on the Syslog server. What can be done to...

Refer to the exhibit. Clients that are connected to Fa0/0 of RTA are only allowed to connect to the Internet and networks, but not the networks on Fa1/0, Fa2/0, Fa3/0 and Fa4/0. To...

You are the network administrator of a medium-sized company, and users are complaining that they cannot send emails to some organizations. During your troubleshooting, you notice t...

Refer to the exhibit. What can be done to remove the summary routes to Null0 on R3?

Refer to the exhibit. R4 is configured as a receive-only EIGRP stub, and is adjacent with 209.165.202.139 (R3). However, R4 is not learning about network 209.165.201.0/27 from R3....

Refer to the exhibit. R4 is a remote office router that is running EIGRP; the decision has been made to change EIGRP to use static EIGRP adjacencies. However, once the configuratio...

Refer to the exhibit. What problem does the debug ip ospf event output from R3 indicate?

Refer to the exhibit. R4 is configured as an OSPF stub; however, R4 should still be learning the OSPF LSA type 3 interarea routes from 209.165.202.130. Which action will solve this...

Refer to the exhibit. An OSPF virtual link is configured between R4 and R3. Based upon the show command output, why is the virtual-link down?

Refer to the exhibit. An OSPF virtual link is configured between RTB and RTA. Based upon the exhibit, why is the virtual link on RTB down?

Refer to the exhibit. Router 1 has three OSPF neighbors, but none of them have routes to the 10.10.10.0 network. Why?

When troubleshooting the issue, you notice the election of a new root bridge with an unknown MAC address. Knowing that all access ports have the PortFast feature enabled, what woul...

You are the network administrator of a small Layer 2 network with 50 users. Lately, users have been complaining that the network is very slow. While troubleshooting, you notice tha...

On a router that is configured with multiple IP SLA probes, which command can be used to manage the CPU load that was created by the periodic probing?

Which configuration would make an IP SLA probe use a precedence value of 3?

Refer to the exhibit. When would the EEM applet be triggered?

Refer to the exhibit. Which of the following options will trigger the applet?

Refer to the exhibit. Which output will the EEM applet in the exhibit produce?

Which NetFlow version should be used to collect accounting data for IPv6 traffic?

To troubleshoot network issues more accurately, milliseconds should be included in the syslog of the router. Which command will achieve this?

Refer to the exhibit. Based on the above commands, when will the output of the show log command be saved?

What is the purpose of an explicit "deny any" statement at the end of an ACL?

Which of these is mandatory when configuring Cisco IOS Firewall?

Which statement correctly describes the disabling of IP TTL propagation in an MPLS network?

Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should...

Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?