350-001 Practice Questions
199 real 350-001 exam questions with expert-verified answers and explanations. Page 1 of 4.
- Question #1
In order to maintain security, with which hop count are IPv6 neighbor discovery packets sent?
- Question #2
Which command will define a VRF with name 'CCIE' in IPv6?
- Question #3
For which routes does LDP advertise a label binding?
- Question #4
Which command can be used on a PE router to connect to a CE router (11.1.1.4) in VRF red?
- Question #5
Refer to the exhibit. This is an MPLS VPN network with OSPF as the PE-CE routing protocol. Which statement is correct?
- Question #6
Which two statements are correct about Nonstop Forwarding? (Choose two.)
- Question #7
Which three fields are optional in an OSPFv3 external LSA? (Choose three.)
- Question #8
On a router, interface S0 is running EIGRPv6, and interface S1 is running OSPFv3. A redistribution command is issued under OSPFv3, redistribute EIGRP 1 metric 20 under ipv6 router...
- Question #9
Which type of domains is interconnected using Multicast Source Discovery Protocol?
- Question #10
Which two multicast address ranges are assigned as source-specific multicast destination addresses and are reserved for use by source-specific applications and protocols? (Choose t...
- Question #11
How is RPF used in multicast routing?
- Question #12
Refer to the exhibit. What does the incoming interface of the above (*,G) entry indicate?
- Question #13
Refer to the exhibit. Which interface(s) will show ip rpf 1.1.1.2 indicate as RPF interface(s)?
- Question #14
Apart from interdomain multicast routing, what else is MSDP used for?
- Question #15
Which IGMPv2 message contains a non-zero "Max Response Time"?
- Question #16
Refer to the exhibit. Which IGMPv2 message is displayed in the output of the packet capture?
- Question #17
What is Phantom RP used for?
- Question #18
Which three statements are true about TACACS+? (Choose three.)
- Question #19
Refer to the exhibit. Which two statements are correct? (Choose two.)
- Question #20
Refer to the exhibit. Which statement is correct?
- Question #21
What does Cisco recommend when you are enabling Cisco IOS IPS?
- Question #22
Refer to the exhibit. Which statement is correct?
- Question #23
Which two statements are true about Unicast Reverse Path Forwarding Loose Mode? (Choose two.)
- Question #24
Refer to the exhibit. What would be the security risk when you are using the above configuration?
- Question #25
Which three protocols should be explicitly managed by using a CoPP policy on an Internet border router? (Choose three.)
- Question #26
What is true about IP Source Guard with port security?
- Question #27
Refer to the exhibit. Which option best describes how the virtual MAC address is composed?
- Question #28
Which two commands are required to enable multicast on a router, knowing that the receivers only supports IGMPv2? (Choose Two)
- Question #29
A branch router is configured with an egress QoS policy that was designed for a total number of 10 concurrent VOIP Calls. Due to Expansion, 15 VOIP Calls are now running over the l...
- Question #30
A new Backup Connection is being deployed on a remote site router. the stability of the connection has been a concern. in order to provide more information to EIGRP Regarding this...
- Question #31
Refer to the exhibit. R1 has an EBGP session to ISP 1 and an EBGP session to ISP 2. R1 receives the same prefixes through both links. Which configuration should be applied so that...
- Question #32
When you are troubleshooting duplex mismatches, which two errors are typically seen on the fullduplex end? (Choose two.)
- Question #33
Which two options are contained in a VTP subset advertisement? (Choose two.)
- Question #34
Which two statements are true about traffic shaping? (Choose two.)
- Question #35
Which three options are features of VTP version 3? (Choose three.)
- Question #36
Which three options are considered in the spanning-tree decision process? (Choose three.)
- Question #37
Refer to the exhibit. A small enterprise connects its office to two ISPs, Using Separate T1 links. A Static Route is used for the default Route, Pointing to both interfaces with a...
- Question #38
Why would a rogue host that is running a DHCP Server on a Campus LAN network present a security risk?
- Question #39
Which Statement is true about TCN Propagation?
- Question #40
Which statement is true about loop guard?
- Question #41
Which two are effects of connecting a network segment that is running 802.1D to a network segment that is running 802.1w? (Choose Two.)
- Question #42
Which command is used to enable Etherchannel hashing for layer 3 IP and Layer 4 Port-based CEF?
- Question #43
In 802.1s, how is the VLAN to instance mapping represented in the BPDU?
- Question #44
Which three combinations are valid LACP configurations that will set up a channel? (Choose three.)
- Question #45
Refer to the exhibit. Which statement is correct about the prefix 160.0.0.0/8?
- Question #46
Which two options does Cisco PfR use to control the entrance link selection with inbound optimization? (Choose two.)
- Question #47
Refer to the exhibit. What is the potential issue with this configuration?
- Question #48
Refer to the exhibit. What triggered the first SPF recalculation?
- Question #49
Which two orders in the BGP Best Path Selection process are correct? (Choose two.)
- Question #50
What is the first thing that happens when IPv6 is enabled on an interface on a host?