200-150 Practice Questions

What are three reasons that switches supersede bridges? (Choose three.)

Which two layers of the OSI model relate to the transmission of bits over the wire and packet forwarding based on destination IP address? (Choose two.)

A network engineer is changing the boot process of a router from its original state to one that boots from ROMMON. Which option in Cisco IOS should be changed?

Which field in an Ethernet II frame performs the same function as the DSAP field in an 802.3 Ethernet frame?

Which command can change the sequence of a router boot process?

A network engineer notices that the MAC address table on a network switch is full. What type of Layer 2 network behavior will occur while the network MAC address table remains full...

Which two features must be licensed on a Cisco Nexus 5548UP Switch? (Choose two.)

Ethernet 1/1 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to configure EIGRP on a Cisco Nexus 7000 switch?

What is the command sequence to force a Cisco Nexus 6000 switch to boot using the golden BIOS image?

The kickstart image is corrupted on a Cisco Nexus 7000 switch. Which procedure is used to download a new kickstart image?

Which situation results in a flashing blue status LED on a Cisco Nexus 7000 switch I/O module?

Which two features must be licensed on a Cisco Nexus 7000 Switch? (Choose two.)

Which two features must be licensed on a Cisco Nexus 5548UP Switch? (Choose two.)

Which two options describe what can happen when devices are in the same broadcast domain? (Choose two.)

If a Nexus switch receives a frame and no MAC table entry is found for the destination, what will take place?

Which three addresses are valid forms of an IPv6 Address: 2001:0DB8:0000:FE01:0000:0000:0000:0000? (Choose three.)

How many bits are in an IPv4 address?

Which two addresses represent multicast addresses? (Choose two.)

At which layer in the OSI stack does the Hypertext Transfer Protocol operate?

What is the order of the OSI stack starting at Layer 1 and ending at Layer 7?

What is the default bridge ID priority for Rapid PVST+?

When connecting a switch port to a virtualization host requiring 802.1q VLAN tagging, which spanning-tree port type should be configured on the switch?

How many bits are used for a subnet ID in an IPv6 address?

Given a subnet address of 10.6.128.0/22, how many IP addresses are usable for this subnet?

In Cisco NX-OS Software, which command redistributes a route of 0.0.0.0/0 into EIGRP?

On a Cisco router, which configuration register setting bypasses the contents of the NVRAM?

Which two naming formats are used to identify an iSCSI node? (Choose two.)

Refer to the exhibit. You are configuring an extended access list to permit a reply from Destination Server B to Source Host A for HTTP traffic. Which extended access list should y...

Which two options are block-based storage protocols? (Choose two.)

Which description of the AAA accounting feature is true?

Refer to the exhibit. Which description of the output is true?

Which statement is true regarding FIP in FCoE enabled Storage Area Networks?

Refer to the exhibit. Regarding the OSI networking model and the updated TCP/IP networking model, which statement about this scenario is true?

On a Cisco Nexus switch, you need to configure an ACL that permits HTTP traffic only from network 10.68.68.0/24 to network 10.68.69.0/24. Which command should you use?

Which statement accurately describes the Single Initiator Single Target zone model?

When using HSRP or VRRP, what are the two states of the router interfaces that are ready to take over forwarding for the link, if necessary? (Choose two.)

When you enter the feature npv command on a storage-capable switch from Cisco, what is the result?

Which protocol data unit is associated with the link layer of the TCP/IP model?

Refer to the exhibit. What type of network communication is depicted?

Which communication type uses a one-to-many model to replicate packets that are delivered to many interested recipients?

Which two protocols are associated with the link layer of the TCP/IP reference model? (Choose two.)

Which protocol is used to encapsulate Fibre Channel frames, enabling them to be transmitted over Ethernet networks?

Which Fibre Channel interface port mode is used to connect multiple switches together?

An administrator connected a new server to a Cisco MDS 9222i on port fc 1/5, but did not capture the world wide node of the host bus adapter. Which command returns the needed infor...

Which two aspects are characteristic of Fibre Channel WWNS? (Choose two.)

In HSRP, how do interfaces determine failure and assign standby and active routers?

What is the maximum working distance of a 1000BASE-ZX SFP transceiver when using ordinary single mode fiber?

Refer to the exhibit. Which type of port is used to connect an edge switch in NPV mode to the core switch?

How does a GLBP cluster respond to a host ARP request for the virtual IP address?

A customer wants to connect to their SAN via Fibre Channel. Which two devices can be used to provide connectivity? (Choose two.)