200-101 Exam Questions

Which two options are valid WAN connectivity methods? (Choose two.)

Refer to the exhibit. Which WAN protocol is being used?

What occurs on a Frame Relay network when the CIR is exceeded?

What are two characteristics of Frame Relay point-to-point subinterfaces? (Choose two.)

Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two.)

Which command allows you to verify the encapsulation type (CISCO or IETF) for a Frame Relay link?

What is the purpose of Inverse ARP?

Refer to the exhibit. A network associate has configured OSPF with the command: City(config-router)# network 192.168.12.64 0.0.0.63 area 0 After completing the configuration, the a...

Refer to the network diagram. Which of the following statements accurately describes a routing entry or network summarization relevant to the Phoenix router's LANs?

What information does a router running a link-state protocol use to build and maintain its topological database? (Choose two.)

Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)

Which type of EIGRP route entry describes a feasible successor?

Drag each description on the left to the appropriate term on the right. Not all the descriptions are used.

Drag the term on the left to its definition on the right (Not all options are used).

Drag the description on the left to the routing protocol on the right. (Not all options are used.)

OSPF is configured using default classful addressing. With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be lea...

After the network has converged, what type of messaging, if any, occurs between R3 and R4?

R1 is configured with the default configuration of OSPF. From the following list of IP addresses configured on R1, which address will the OSPF process select as the router ID?

If required, what password should be configured on the DeepSouth router in the branch office to allow a connection to be established with the MidEast router?

What would be the destination Layer 2 address in the frame header for a frame that is being forwarded by Dubai to the host address of 172.30.4.4?

Which connection uses the default encapsulation for serial interfaces on Cisco routers?

A static map to the S-AMER location is required. Which command should be used to create this map?

Central Florida Widgets recently installed a new router in their Gotha office. Complete the network installation by performing the initial router configurations and configuring RIP...

Which command displays the CHAP authentication process as it occurs between two routers?

A department decided to replace its hub with a Catalyst 2950 switch that is no longer needed by another department. To prepare the switch for installation, the network administrato...

Refer to the exhibit. The following commands are executed on interface fa0/1 of 2950 Switch. ``` 2950Switch(config-if)# switchport port-security 2950Switch(config-if)# switchport p...

Which two statements describe characteristics of IPv6 unicast addressing? (Choose two.)

What are three features of the IPv6 protocol? (Choose three.)

A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and withou...

Refer to the graphic. Users on the Holyoke router are unable to access the intranet server attached to interface E0 of the Chicopee router. Inspection of the routing table of the H...

Refer to the exhibit. What can be determined about the interfaces of the Main_Campus router from the output shown?

Select the action that results from executing these commands. ``` Switch(config-if)# switchport port-security Switch(config-if)# switchport port-security mac-address sticky ```

Which two of these statements are true of IPv6 address representation? (Choose two.)

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

What are three benefits of GLBP? (Choose three.)

What command visualizes the general NetFlow data on the command line?

What are three reasons to collect Netflow data on a company network? (Choose three.)

What are three factors a network administrator must consider before implementing Netflow in the network? (Choose three.)

What are the benefit of using Netflow? (Choose three.)

What are the three things that the Netflow uses to consider the traffic to be in a same flow?

Which three are the components of SNMP? (Choose three)

What are the Popular destinations for syslog messages to be saved?

Syslog was configured with a level 3 trap. Which 3 types of logs would be generated (choose three)

Which three statements about Syslog utilization are true? (Choose three.)

A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? (Choose three.)

What is the default Syslog facility level?

What command instructs the device to timestamp Syslog debug messages in milliseconds?

Refer to the exhibit. What is the cause of the Syslog output messages?

What is the alert message generated by SNMP agents called ?

Which three features are added in SNMPv3 over SNMPv2?