200-101 Exam Questions

Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?

Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?

Which switch services the printers?

Which two of these statements regarding RSTP are correct? (Choose two.)

Which port state is introduced by Rapid-PVST?

Which three of these show the correct RSTP port roles for the indicated switches and interfaces? (Choose three.)

Which two states are the port states when RSTP has converged? (Choose two.)

Which three statements about RSTP are true? (Choose three.)

At which layer of the OSI model is RSTP used to prevent loops?

What is one benefit of PVST+?

What are three characteristics of the OSPF routing protocol? (Choose three.)

Which statement is true, as relates to classful or classless routing?

Which parameter or parameters are used to calculate OSPF cost in Cisco routers?

Which statements are true about EIGRP successor routes? (Choose two.)

Refer to the exhibit. Which two statements are true about a loopback interface that is configured on the Core router. All the connections to the branches should participate in OSPF...

Refer to the exhibit. Which two statements are true about a loopback address that is configured on RouterB? (Choose two.)

What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?

Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?

What are two drawbacks of implementing a link-state routing protocol? (Choose two.)

Which two are advantages of static routing when compared to dynamic routing? (Choose two.)

Which command enables IPv6 forwarding on a Cisco router?

A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network. If there ar...

Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork per...

What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is in active status?

Referring to the exhibit, which of the following is the correct `show ip route` output for Router A to reach networks 208.149.23.64/27 and 208.149.23.96/27?

Which command is used to display the collection of OSPF link states?

What is the default administrative distance of OSPF?

The following configuration is applied to a Layer 2 Switch: ``` interface fastethernet 0/4 switchport mode access switchport port-security switchport port-security mac-address 0000...

Refer to the exhibit. Which of these correctly describes the results of port security violation of an unknown packet? ``` Switch(config)#interface fastethernet 0/1 Switch(config-if...

Refer to the exhibit. When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?

Which term describes a spanning-tree network that has all switch ports in either the blocking or forwarding state?

Refer to the exhibit. A technician has configured the FastEthernet 0/1 interface on Sw11 as an access link in VLAN 1. Based on the output from the show vlan brief command issued on...

What command is used to verify the DLCI destination address in a Frame Relay static configuration?

Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156?

Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is shown in the exhibit? (Choose two.)

What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub-in a hub-and-spoke topology?

Which two statistics appear in show frame-relay map output? (Choose two.)

Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?

At which layer of the OSI model does PPP perform?

The command show frame-relay map gives the following output: Serial 0 (up): ip 192.168.151.4 dlci 122, dynamic, broadcast, status defined, active Which statements represent what is...

What can be done to Frame Relay to resolve split-horizon issues?(Choose two.)

What are three reasons that an organization with multiple branch offices and roaming users might implement a Cisco VPN solution instead of point-to-point WAN links? (Choose three.)

Which command is used to enable CHAP authentication, with PAP as the fallback method, on a serial interface?

What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?

Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router. How should the networ...

Refer to the exhibit. Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?

Refer to the exhibit. Given the output from the show ip eigrp topology command, which router is the feasible successor?