What command is used to verify the DLCI destination address in a Frame Relay static configuration?

The correct answer is C. show frame-relay map. The 'show frame-relay map' command displays the static and dynamic mappings between Layer 3 protocol addresses (e.g., IP addresses) and their corresponding Layer 2 DLCI (Data Link Connection Identifier) values. In a static Frame Relay configuration, you manually define these…

Implement Wide-Area Networks

Question

What command is used to verify the DLCI destination address in a Frame Relay static configuration?

Options

Ashow frame-relay pvc
Bshow frame-relay lmi
Cshow frame-relay map
Dshow frame-relay end-to-end

How the community answered

(30 responses)

A
3% (1)
C
90% (27)
D
7% (2)

Explanation

The 'show frame-relay map' command displays the static and dynamic mappings between Layer 3 protocol addresses (e.g., IP addresses) and their corresponding Layer 2 DLCI (Data Link Connection Identifier) values. In a static Frame Relay configuration, you manually define these mappings using the 'frame-relay map' command, and 'show frame-relay map' is the correct command to verify that the DLCI-to-destination-address mapping is correct. By contrast, 'show frame-relay pvc' shows PVC statistics (BECN, FECN, traffic counters), 'show frame-relay lmi' shows LMI signaling statistics, and 'show frame-relay end-to-end' is not a valid Cisco IOS command.

Topics

#Frame Relay#DLCI#show frame-relay map#static mapping

Community Discussion

No community discussion yet for this question.

Full 200-101 Practice