200-101 Exam Questions

What are three components that comprise the SNMP framework? (Choose three.)

What SNMP message alerts the manager to a condition on the network?

What authentication type is used by SNMPv2?

Which three statements about the features of SNMPv2 and SNMPv3 are true? (Choose three.)

What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?

In a GLBP network, who is responsible for the arp request?

In GLBP, which router will respond to client ARP requests?

Which three statements about HSRP operation are true? (Choose three.)

What is a valid HSRP virtual MAC address?

Identify the fault(s) and correct the router configuration(s) to provide full connectivity between the routers, specifically ensuring connectivity for the ENG router to the ISP rou...

After adding ENG router, no routing updates are being exchanged between MGT and the new location. All other inter connectivity for the existing locations of the company are working...

Refer to the exhibit. How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?

Refer to the exhibit. A junior network engineer has prepared the exhibited configuration file. What two statements are true of the planned configuration for interface fa0/1? (Choos...

What is the default Local Management Interface frame type transmitted by a Cisco router on a Frame Relay circuit?

Refer to the exhibit. The network shown in the exhibit has just been installed. Host B is unable to ping host C. What is the problem with this configuration?

Which protocol provides a method of sharing VLAN configuration information between switches?

Refer to the exhibit. What is the most appropriate summarization for these routes?

The network administrator has been asked to give reasons for moving from IPv4 to IPv6. What are two valid reasons for adopting IPv6 over IPv4? (Choose two.)

The network technician is planning to use the 255.255.255.224 subnet mask on the network. Which three valid IP addresses can the technician use for the hosts? (Choose three.)

Which of these represents an IPv6 link-local address?

Refer to the graphic and routing table for router R1. Based on the output of the R1# show ip route command and the information presented in the graphic, which of the following is a...

An administrator is troubleshooting a problem between routers that are using different versions of RIP. Which two commands would provide information about which version of RIP was...

Refer to the exhibit. You are connected to the router as user Mike. Which command allows you to see output from the OSPF debug command?

Refer to the exhibit. Which route will be found in the routing table of the Main router?

Refer to the exhibit. A technician is testing connection problems in the internetwork. What is the problem indicated by the output from HostA?

An organization is concerned that too many employees are wasting company time accessing the Internet. Which access list statement would stop World Wide Web access for employees on...

Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new...

Workstation A has been assigned an IP address of 192.0.2.24/28. Workstation B has been assigned an IP address of 192.0.2.100/28. The two workstations are connected with a straight-...

Refer to the exhibit. How many interfaces on R1 should be configured as ip nat inside to grant external access to the entire network?

Refer to the exhibit. Host A pings interface S0/0 on router 3. What is the TTL value for that ping?

Refer to the exhibit. A network engineer is troubleshooting an Internet connectivity problem on the computer. What is causing the problem?

Refer to the exhibit which shows a PC's IP configuration (IP Address: 192.168.1.12, Subnet Mask: 255.255.255.0, Default Gateway: 192.168.1.1, DNS Services: 192.168.1.1) and a route...

Refer to the exhibit. Which address range efficiently summarizes the routing table of the addresses for Router Main?

Refer to the exhibit. The router has been configured with these commands: hostname Gateway interface FastEthernet 0/0 ip address 198.133.219.14 255.255.255.248 no shutdown interfac...

Refer to the exhibit. What can be concluded from the output of the debug command?

Refer to the output from the show running-config command in the exhibit. What should the administrator do to allow the workstations connected to the FastEthernet 0/0 interface to o...

Refer to the exhibit. HostA cannot ping HostB. Assuming routing is properly configured, what could be the cause of this problem?

Which two data integrity algorithms are commonly used in VPN solutions? (Choose two.)

What are three benefits of implementing VLANs? (Choose three.)

The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and wa...

Which address is the IPv6 all-RIP-routers multicast group address that is used by RIPng as the destination address for RIP updates?

Which command shows your active Telnet connections?

Which component of VPN technology ensures that data is unaltered between the sender and recipient?

What is the alternative notation for the IPv6 address B514:8263:0000:0000:0029:EC7A:0600:EC72?

In which integration method is an IPv6 packet encapsulated within an IPv4 protocol?

Refer to the exhibit. How should Switch1 and Switch2 be connected in order to allow full communication between all of the hosts?

Refer to the exhibit. Some 2950 series switches are connected to the conference area of the corporate headquarters network. The switches provide two to three jacks per conference r...

Refer to the exhibit. Which two statements about the configuration of the switch interface are correct? (Choose two.)

Which three elements must be used when you configure a router interface for VLAN trunking? (Choose three.)