SG0-001 Exam Questions
609 real SG0-001 exam questions with expert-verified answers and explanations. Page 11 of 13.
- Question #501Storage Connectivity
When connecting two FC switches using FCIP across an IP circuit, which of the following ensures that the FC frames are not segmented?
FCIPJumbo framesFC framesNetwork optimization - Question #502Storage Management
In a performance tiered storage environment, which of the following types of data should reside on the top tier?
Storage tieringPerformance optimizationHigh I/O - Question #503Storage Management
In an HSM archive application, which of the following is the BEST candidate for migration?
HSMData migrationArchiving strategyLeast accessed data - Question #504Storage Management
A SAN administrator is adding a new server with dual HBAs to a fully redundant SAN. After committing the zoning changes, several servers lost half their connectivity to the storage...
SAN troubleshootingFibre Channel zoningZone set activationConnectivity loss - Question #505Storage Connectivity
Which of the following is the purpose of ISL?
ISLFibre Channel fabricFC switches - Question #506Storage Implementation
Which of the following is required for the proper environment of a storage array?
Data center infrastructureHVACEnvironmental control - Question #507Storage Implementation
An administrator installed a new NIC into an existing older server. The NIC is not properly recognized by the OS. Which of the following is MOST likely the problem?
NIC installationDevice driversHardware troubleshooting - Question #508Storage Management
Which of the following is a component of LVM?
LVMVolume groupLogical volumes - Question #509Storage Connectivity
Which of the following is the purpose of VLAN technology?
VLANNetwork segmentationTraffic isolation - Question #510Storage Management
Which of the following is MOST likely required to have true site redundancy?
Disaster RecoverySite redundancyBusiness continuity - Question #511Storage Functionality
Which of the following RAID levels would allow a technician to take advantage of distributed parity and lose any two drives in a RAID group without losing data?
RAIDRAID 6Data redundancyDistributed parity - Question #512Storage Connectivity
Which of the following port combinations is correct for a link between an FC router and a switch?
Fibre Channel portsE_PortEX_PortFC router - Question #513Storage Components
In order to decrease the amount of time required to backup hosts, disk drive arrays can be used to simulate tape drives for backup. Which of the following can be used for this purp...
VTLVirtual Tape LibraryBackup solutions - Question #514Storage Management
An administrator would like to lower storage costs by only keeping frequently accessed data on FC disks, less accessed data on low cost SATA disks, and seldom accessed data on opti...
HSMStorage tieringData lifecycle managementCost optimization - Question #515Storage Functionality
When considering an HA FC environment, a Single Point of Failure (SPOF) between the storage and the server is:
High AvailabilitySPOFFibre ChannelRedundancy - Question #516Storage Connectivity
Which of the following represents a best practice in an HA FC environment?
High AvailabilityDual fabricsFibre ChannelRedundancy - Question #517Storage Management
The same LUN can be mapped to multiple servers only if which of the following conditions are satisfied?
LUN mappingShared storageCluster file systemData integrity - Question #518Storage Components
Which of the following is one advantage of using TOE?
TOETCP Offload EngineCPU utilization - Question #519Storage Connectivity
In order to enable Linux hosts to access a NAS share, which of the following protocols MUST be enabled?
NASNFSLinuxFile sharing protocols - Question #520Storage Connectivity
Which of the following, when enabled on all devices, will decrease the number of packets sent on the network?
Jumbo framesNetwork performancePacket optimization - Question #521Storage Functionality
In order to avoid shoe-shining, which of the following techniques can be used?
Tape storageData streamingTape drive optimizationMultiplexing - Question #522Storage Connectivity
In a fully redundant dual fabric environment, the core switch in one of the fabrics fails. None of the servers can access their LUNs. Which of the following is a possible cause of...
SAN redundancyDual fabricSingle point of failureStorage controllers - Question #523Storage Components
Which of the following technologies has the FASTEST hard drive interface?
Drive interfacesSAS-2SATAFibre Channel - Question #524Storage Management
Best zoning practice dictates that each zone can only contain a single:
SAN zoningFibre ChannelInitiator-targetBest practices - Question #525Storage Implementation
While reviewing a new installation the storage administrator notices that a number of FC cables have excess length that is tightly looped. Of which of the following would this be a...
Fibre Channel cablingCable managementBend radiusInstallation best practices - Question #526Storage Components
Which of the following devices would allow a storage administrator to implement Fibre Channel over Ethernet (FCoE)?
FCoECNANetwork adaptersFibre Channel - Question #527Storage Functionality
Which of the following would be BEST to ensure data immutability?
Data immutabilityWORMData archivingCompliance - Question #528Storage Functionality
During a power outage of a datacenter, a storage array did not shut down in a vendor's recommended fashion. When power is restored, the servers connected to the array indicate that...
Storage array cacheData corruptionPower outageData integrity - Question #529Storage Functionality
High availability in a storage environment implies that:
High availabilityRedundancySingle point of failureFault tolerance - Question #530Storage Connectivity
While testing access to Server A on a remote subnet, a storage administrator is unable to connect from their workstation. The administrator is only able to connect to Server B whic...
Network troubleshootingFirewall rulesSubnettingRemote access - Question #531Storage Implementation
When Server A accesses an FC based storage array, it experiences a coredump. Server B accesses the same array, and does not experience this issue. Which of the following should the...
Fibre Channel troubleshootingHBA driversServer coredumpStorage connectivity - Question #532Storage Components
How many physical paths are supported on a SAS drive?
SAS drivesDrive interfacesMultipathingRedundancy - Question #533Storage Management
How many initiators per zone should be used to adhere to BEST SAN zoning practices?
SAN zoningFibre ChannelInitiator-targetBest practices - Question #534Storage Connectivity
Which of the following protocols would be used on a host to access network share called \\server1.chicago.net\data?
Network file sharingCIFSSMBFile protocols - Question #535Storage Functionality
If a server reads 2MB of data using 4KB block size in 1 second from a storage array, how many IOPS have been generated?
IOPS calculationStorage performanceBlock sizeThroughput - Question #536Storage Functionality
Which of the following would BEST ensure equal I/O distribution across all paths?
MultipathingLoad balancingI/O distributionRound Robin - Question #537Storage Connectivity
When trying to connect with a damaged network cable, which of the following will MOST likely result from the bad cable?
Network troubleshootingCable damagePacket lossPhysical layer - Question #538Storage Connectivity
If the nslookup command is not available on the host, which of the following is the BEST command to resolve fully qualified domain name to IP address of a remote host?
Network troubleshootingDNS resolutionPing commandFQDN - Question #539Storage Connectivity
After an overnight upgrade during which equipment was moved, a server has become very slow in the fabric and the error rate is high. Which of the following should a technician chec...
Fibre Channel troubleshootingCable issuesPhysical layerError rates - Question #540Storage Connectivity
Which of the following measures the performance overhead in an ISL between two switches?
SAN performanceISLLatencyNetwork overhead - Question #541Storage Functionality
Which of the following RAID levels can be implemented with three hard drives but has the HIGHEST latency? (Select TWO).
RAID levelsRAID latencyRAID 3RAID 4 - Question #542Storage Management
A biometric device is BEST used for which of the following purposes?
biometric devicephysical securityaccess control - Question #543Storage Management
A user can connect to a shared folder on a NAS device, but cannot access any files inside of the folder. Which of the following security settings need to be changed to grant the us...
NAS permissionsshare permissionsfile permissionsaccess control - Question #544Storage Management
Which of the following documentation should be referenced FIRST when deciding how long to retain backup data?
data retentionbackup policycorporate compliancelegal requirements - Question #545Storage Management
Which of the following protocols is MOST likely used to generate events for review by an administrator?
SNMPnetwork monitoringevent managementstorage management protocols - Question #546Storage Management
A storage administrator has just installed a new SAN. Which of the following should the administrator establish for performance monitoring purposes?
SAN performance monitoringperformance baselinecapacity planning - Question #547Storage Connectivity
A new storage system with dual storage controllers is added to an HA SAN. The storage administrator attempts to zone a dual HBA host to the new storage system but can only connect...
SAN troubleshootingFibre Channel zoningHA SANdual controllersfabric connectivity - Question #548Storage Functionality
Which of the following RAID levels offers the HIGHEST level of protection with the shortest rebuild time?
RAID levelsRAID protectionRAID rebuild timeRAID 10 - Question #549Storage Implementation
The disk drives supporting an I/O intensive mission critical application are continuously 80 percent utilized and spike up to 100 percent throughout the business day. Which of the...
storage performanceSSDFibre Channel drivesI/O intensive applicationsperformance tuning - Question #550Storage Implementation
A Chief Information Officer (CIO) has determined that creating a highly available environment is desirable, but budget concerns will dictate what redundancy is added in the near fu...
high availability (HA)SAN designredundancyFibre Channel fabricHBA configuration