JN0-363 Exam Questions

Referring to the exhibit. Which prefix in the output shown in the exhibit is an external prefix injected by an OSPF router?

Which statement describes integrated routing and bridging (IRB) interfaces?

The LSP is not establishing correctly. Referring to the exhibit, what should you do to solve the problem?

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority has been configured. Which statement is true in this scenario?

What is a key differentiator of generate routes from aggregate routes?

Which statement is correct about the FE80::/10 prefix?

You are deploying link aggregation groups. By default, what are two considerations in this scenario? (Choose two.)

Referring to the exhibit. You are asked to assign interface xe-1/0/5 to a virtual switch. What must be accomplished to complete the configuration?

Referring to the exhibit, which statement is true about VRRP?

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing ta...

What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)

You are asked to configure the OSPF environment to prevent the DRother routers from participating in DR/BDR election. Referring to the exhibit, which command will accomplish this t...

Referring to the exhibit. Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the e...

Referring to the exhibit, which two statements are correct? (Choose two.)

Referring to the exhibit. You have an established LSP between your R1 and R5 devices using the configuration shown in the exhibit. You are asked to ensure that MPLS labels are used...

Referring to the exhibit. Which two statements are correct about the information shown in the exhibit? (Choose two.)

Referring to the exhibit. You are advertising a summary route that represents your local network (172.20.0.0716) to both ISP A and ISPB. You want to influence all traffic sent to y...

Which two statements ate correct about the community BGP attribute on a Junos device? (Choose two.)

Referring to the exhibit, how do you verify the status of the tunnel from R1?

You are asked to configure an LSP which uses the OSPF link state database for path computations. Which two statements are correct in this scenario? (Choose two.)

The segment touting SRGB start label Is 10,000 and the SRGB index range is 500. In this scenario, which two statements are correct? (Choose two.)

Referring to the exhibit. You configured interface ge-0/070.0 to run IS-IS. but this interface does not appear in the output of the show isis adjacency command as shown in the exhi...

Referring to the exhibit. The routers shown in the exhibit are configured for segment routing. In this scenario, what is the adjacency SID that Router B advertises to Router A?

An OSPF router does not have a router ID configured. In this scenario, which statement is correct about the router ID?

You want to see a detailed list of all established BGP sessions. In this scenario, what would be a valid command to accomplish this task?

What are three types of MPLS routers? (Choose three.)

Referring to the exhibit. You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses. Which two tasks will accomplish your objective? (Choose two.)

You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy thi...

Referring to the exhibit. Which type of load balancing is shown in the exhibit?

Referring to the exhibit. Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

You have created a routing instance named vr3 that will provide access to Server 2 (10.0.0.2) (or the hosts on the 10.10.10.0/24 network. Which command would you use to test connec...

Referring to the exhibit. Routers R1 and R4 have a VRRP priority of 90, while R2 and R3 have default VRRP priorities Referring to the exhibit, which router will be elected as the p...

Referring to the exhibit, what will happen to untagged frames?

Referring to the exhibit, internal BGP between R1 and R2 is not establishing. What is the problem In this scenario?

Referring to the exhibit, which two additional steps should you lake to fully configure NSR? (Choose two.)

You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command. Referring to the exhibit, what is the problem?

Which BGP attribute Is used to detect touting loops?

Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)

How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Referring to the exhibit, what must be included in the Route1 configuration when establishing an EBGP session with the ISP?

Referring to the exhibit, what is the minimum number of LSPs required to support all four networks?

You are bringing a new network online with three IS-IS routers using default Junos election priorities. The routers are configured as Level 2 only IS-IS routers. Which statement is...

You are asked to configure filter-based forwarding on a Junos device. Which two statements are correct in this scenario? (Choose two.)

Referring to the exhibit, which statement is correct?

Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)

Which OSPF database packet determines which router is in charge of the database synchronization and the transferring of LSA headers between the two systems?

You want to share routes between two routing instances that you have configured? What are two ways to accomplish this task? (Choose two.)

You are implementing traffic engineering in your MPLS network. You must ensure that the MPLS routes are used to traverse your network. Your solution should not affect IGP routes in...

Which two protocols are capable of distributing labels for segment routing? (Choose two.)