300-540 Exam Questions

Which two tools should be used to manage container orchestration? (Choose two.)

Refer to the exhibit. An engineer is troubleshooting an issue where switch LEAF-SW-1 and switch LEAF-SW-2 receive corrupted forwarding and learning information about each other. LE...

What is an information-gathering capability of Cisco IOS Flexible NetFlow in Cisco NFVI?

Which two network segments are needed to support Cisco VIM? (Choose two.)

Refer to the exhibit. An engineer is troubleshooting an issue with switch LEAF-SW-11. The engineer observes that several main servers on the VXLAN BGP EVPN Multi-Site network exper...

What is a benefit of using machine learning in Cisco AFM?

An engineer must implement a SaaS solution that will use a Cisco ASAv to enhance security for enterprise customers by using Cisco Crosswork NSO. Which command must be run in NSO?

A virtual private cloud (VPC) is implemented to provide __________ isolation within a public cloud environment.

RTBH is effective in mitigating what kind of traffic?

When troubleshooting DCI solutions, which of the following tools or concepts are crucial? (Choose two)

Refer to the exhibit. An engineer must configure redundancy by deploying three Cisco vSmart Controllers in each data center. Which two actions must be taken to configure controller...

Which command must be run on a Cisco IOS device to configure six parallel iBGP and eBGP routes that can be installed into a routing table?

Refer to the exhibit. An engineer must design a solution that creates a low-latency slice based on a link latency measurement by using the MPLS performance measurement. The solutio...

How does log management assist in meeting the requirements of cloud security regulatory compliance?

Refer to the exhibit. An engineer must configure dual-homing with single active redundancy in a BGP EVPN VXLAN fabric. Which command must be run on the leaf router to complete the...

Refer to the exhibit. An engineer must stop a DoS attack on web and mail servers by using destination-based RTBH routing. Which two commands must be run on router R1? (Choose two)

Refer to the exhibit. An engineer must configure EVPN port-active multihoming on router R1. Which command must be run against the g1/0 and g1/1 interfaces on R1 to complete the phy...

An engineer must design a high-availability solution that provides path redundancy for IP by allowing redundant gateways to share MAC protocols and addresses. A group of Layer 3 ro...

What does enabling gRPC allow in Cisco NFVI Assurance and Monitoring?

Refer to the exhibit. An engineer is troubleshooting an issue where Cisco switch Switch_A fails to establish OTV connectivity to Cisco switch Switch_C. What is the cause of the iss...

Refer to the exhibit. An engineer needs to configure ToR switches for a Cisco NFVI C-series pod. This configuration was performed on the ToR-A switch already: feature vpc feature l...