Refer to the exhibit. An engineer needs to configure ToR switches for a Cisco NFVI C-series pod. This configuration was performed on the ToR-A switch already: feature vpc feature lacp interface Ethern

Question

Exhibit

Options

• Avpc peer-link
• Bpeer-keepalive destination 10.10.10.2
• Cchannel-group 110 mode on
• Dswitchport mode access

• A
  10% (4)
• B
  82% (32)
• C
  3% (1)
• D
  5% (2)

Explanation

In a Cisco NFVI C-Series Pod, the Top-of-Rack (ToR) switches are almost always configured as A vPC domain requires three mandatory components: vPC peer-keepalive link ensures dual-active detection The management interfaces are Tor-A Mgmt0: 10.10.10.1 and Tor-B Mgmt0: 10.10.10.2 These IPs are used commonly as the peer-keepalive endpoints The physical uplinks to NFVI nodes form Port-Channel110 Since the configuration snippet already includes: channel-group 110 mode active The next required step in a Cisco NFVI + vPC configuration is to configure the peer-keepalive from ToR-A toward ToR-B: peer-keepalive destination 10.10.10.2 Dual-active prevention Stable operation for the NFVI C-Series rack Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, Microsoft, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test, First Pass. Help you to pass any IT Certification exams at the first try. You can reach us at any of the email addresses listed below. Any problems about IT certification or our products, you could rely upon us, we will give you satisfactory answers in 24 hours.

No community discussion yet for this question.