300-370 Exam Questions

A client cannot authenticate, down to authentication server unable to process quick enough due to CPU. What can be done to alleviate this?

A client protection enabled on WLAN ID 1 some clients unable to connect

What is WCS report used to check worst SNR in mesh link?

When RTLS is used?

Drag and Drop Question No PoE On Only One Port, arrange the steps in correct order.

Debug missing RFID

Where is the CAS license installed?

Rogue prevention

Cisco WLC v7.0 is configured on 2.4 GHz for mandatory data rates of 9 and 18 Mb/s. Data rates of 6, 12, 24, 36, 48, and 54 Mb/s are configured as supported. All other data rates ar...

Which Cisco WLC debug command would allow you to determine if the certificate process is failing in the CAPWAP messages?

which method is used by Cisco WLC v7.0 for the autoinstall process?

Cisco WCS v7.0 using a Cisco 3300 Series MSE can map and track wireless clients but is unable to track RSSI-based RFID tags. What is the most likely cause of this problem?

When planning on implementing Enhanced Local Mode scanning, tracking RF interference devices (CleanAir), RFID tags that are based on TDoA, and wireless clients, what is needed for...

An engineer is troubleshooting reports from a Cisco 7925 user that is experiencing consistent gaps in audio when roaming from one area of the facility to another. Packet analysis s...

Which modulation, which was introduced in 802.11ac standard, influences end-user experience by providing the highest data rates and throughput?

An engineer is troubleshooting why a MAC address was not listed in the MAC table and discovers that the VLAN was enabled only on the interface that data is coming in on. Which chan...

Refer to the exhibit. Which two statements about the WLAN are true? (Choose two.)

An engineer has discovered that a number of new access points are failing to join the wireless controller module that has been recently enabled on a switch stack of three Cisco Cat...

Refer to the exhibit. What is the highest mandatory rate in Mpbs configured for the AP?

From the WLC GUI, which RRM setting do you configure to avoid non-Wi-Fi interference?

In a high-density deployment on a customer site with ID 339696181, how do you mitigate the cell size in a large coverage area?

You install a WLAN in a warehouse environment for a customer. three months after the installation, the customer reports that the devices in the environment show a poor RSSI is some...

A training class has 15 laptops connecting to the WLAN using the same Active Directory training credentials. Users report that they cannot connect until someone else logs off. At a...

Refer to the exhibit. An access point joins the secondary wireless controller but not the primary wireless controller. Another access point has joined the controller and is working...

You have a single Cisco 5508 WLC with a management IP address of 172.16.24.5/24. You need to register 50 new Cisco AIR-CAP3702I-E-K9. Access Points to the WLC using DHCP option 43....

Refer to the exhibits. An engineer is troubleshooting connectivity issues on the guest network. Which cause of the issue is true?

Which statement about the process of rogue containment performed on a rogue AP and rogue clients is true?

Refer to the exhibit. Which troubleshooting approach is represented?

Refer to the exhibit. Which option prevents the AP from completing the DTLS join process?

Which three options are characteristics of a rogue AP that poses a high-security risk? (Choose three.)

Which three details are contained within the LWAPP discovery response sent by each WLC to enable the LAP to choose a WLC? (Choose three.)

An engineer is troubleshooting a DHCP configuration that is being used to discover two WLCs with the IP addresses of 192.168.10.10 and 192.168.10.11. Which string is used for confi...

After you perform a post-installation RF survey for a customer with ID 339696181, you discover that all areas have at least -67 dBm RSSI, 25 dB SNR, and 10 percent cell overlap. Th...

While you investigate wireless connectivity issues, a user reports that only certain devices are affected. You use a wireless protocol analyzer to capture 802.11 frames. The captur...

An engineer is attempting to resolve wireless channel overlap issues in the 2.4 GHz network. Which network change reduces channel overlap?

Refer to the exhibit. Which configuration must be addresses to correct this issue?

You recently deployed an 802.11ac wireless network that contains Cisco Unified Wireless IP Phones 7925G. Users report that the phones intermittently lose connectivity. Which troubl...

You are troubleshooting an AP that fails to join a WLC. Which step of the DTLS handshake is first when establishing a secure CAPWAP connection?

Which three options can be configured as roaming triggers on a WGB? (Choose three.)

All corporate-issued devices in your network have been configured with EAP-TLS authentication. They authenticate via wireless to an instance of Cisco ISE and AD authorization for t...

Clients are maintaining association to access points that they were previously connected to rather than roaming to adjacent access points with higher received signal strength. Whic...

Refer to the exhibit. An engineer has determined that during a recent controller failure, some access points did not fail over to their secondary controller, which has sufficient l...

Which three components are needed to identify the zone of impact for non-802.11 sources of 2.4 GHz and 5.0 GHz interference? (Choose three.)

You detect a coverage hole in some part of the network. After troubleshooting, you find out that the Cisco 3702i AP is not using all of its transmission power, and hence is not usi...

Refer to the exhibit. Why did Client 00:25:84:61:92:7d not get a response from the RADIUS server?

Refer to the exhibit. An engineer is troubleshooting non-802.11 interference and observes the shown output. Which interference signature is depicted?

An engineer wants to run the Voice Audit tool in PI and wants to be able to verify: - that clients will be capable of having static IPs - whether or not Call Admission Control is e...

When designing your wireless network for iOS devices, which two limits of packet loss and jitter ensure stable, quality communication? (Choose two.)

You are troubleshooting an AP joining issue. You have captured the CAPWAP join request sent from the AP to the controller. Which information do you export?

An engineer ran the debug packet logging enable all command, but only 25 packets are shown and none from the client the engineer wants to see. Which command helps find data that is...