300-360 Exam Questions

An engineer is preparing for an active site survey of a hospital and is informed that he or she should not enter any active surgery suites. Which option describes how the engineer...

An access point will be partially exposed to the outdoor environment in a loading dock of a factory. How should this access point be deployed in a cost-effective manner?

Which two information points should a pre-site survey questionnaire contain? (Choose two.)

A customer has determined that aesthetics is a primary concern for their upcoming guest deployment. Which design consideration can be leveraged to address this concern?

You deploy a wireless network for a common area located outside of a student dorm by using patch antennas. Students report weak signals in specific locations of the coverage area....

IEEE 802.11r-2008 or fast BSS transition (FT), also called "fast roaming," Which 802.11 standard performs the PTK calculations in advance to enable fast client roaming?

Which three network located in a warehouse? (Choose three.)

During a post-deployment survey, the wireless engineer notices that offices in surrounding suites also have wireless networks and the 2.4 Ghz band is highly utilized Which configur...

An engineer must design a wireless voice network and is auditing the existing configuration. Which two actions must be taken? (Choose two.)

An engineer is implementing Q0S for a new wireless voice network. Which two considerations should be identified first? (Choose two.)

An engineer is determining powering requirements for a P2P wireless link using Cisco Aironet 1572EC access points. Which power method is valid for the access point?

17.A network engineer is performing a site survey in preparation for an installation. Which three hardware parameters must be inspected? (Choose three.)

An engineer has added an access point to a deployment after a post-installation site survey. The engineer then notices that there has been an increase in co-channel interference an...

You are planning the coverage for wireless VoIP by using Ekahau. Which signal strength does Ekahau recommend using for VoIP?

You must upgrade a data-based wireless network to support Voice over Wireless. Which RSSI measurement do you use to redesign the wireless network?

You must create a simple implementation of QoS on a WIAN. The implementation must allow clients to prioritize traffic into these four classes: - voice - video - best effort - backg...

A post-deployment active wireless site survey was just completed for a company. Which two pieces of information must be included in the site survey report? (Choose two.)

An engineer wants the controller to report when a client exceeds the minimum acceptable RSSI level, to ensure support for the minimum data rate required. Which controller option mu...

During an installation of a wireless network in a country that follows ETSI standards, the customer is requesting to manually set the channels on the 2.4GHz radios. Which channels...

A customer wants to upgrade their current wireless infrastructure to support wireless voice capabilities. When using a voice readiness assessment tool, the customer notes that mult...

You are designing an outdoor mesh network to cover several sports fields. The core of the network is located in a building at the entrance of a sports complex. Which type of antenn...

An engineer is preparing for an active site survey of a warehouse and is informed that they should not enter any areas that are blocked by supplies that are difficult to move. Whic...

Which description of the ideal VoWLAN design is true?

A wireless engineer is hired to troubleshoot wireless network issues and discovers that the customer is using 802 11 ac access points with 80 MHz-wide channels in a high-density en...

A customer has determined that a cable run for a low-throughput RF design is not economically feasible to install. Which two access point modes can alleviate these customer concern...

An engineer is concerned with the compliance guidelines for human exposure to a rooftop RF transmitter that has been recently installed. What regulation should be reviewed to ensur...

You must redesign an existing wireless network that spans multiple floors to support location- based services. Where do you install the access points?

You are designing a wireless mesh network for an oil refinery. What is the Cisco-recommended model of a Cisco Aironet 1550 Series Outdoor Access Point for this location?

A company has deployed a centralized wireless architecture a their headquarters. In this type of deployment, to which network layer do you recommend that the WLC connect?

Which three parameters are used by Cisco Prime Infrastructure to generate heat maps? (Choose three.)

An engineer has performed a post-deployment site survey and noticed that access points were installed in suboptimal locations due to physical restrictions and obstacles. Which acti...

An engineer is deploying outdoor Cisco Aironet 1500 Series Access Points and wants to protect the network from overvoltage transients. Which two protection methods must be used? (C...

A wireless engineer is configuring VoWLAN on a WLC. Which configuration should be implemented on the router or switch that is connected to the WLC?

A customer is preparing to deploy a wireless network in a stadium and is identifying coverage area requirement for the patrons in suite areas. Which two attributes are relevant to...

Which purpose of using Metageek Chanalyzer during site survey is true?

When should a Layer I site survey be performed?

After installation of a new data-only wireless network, an engineer found that RRM has set all of the APs to a power level of 1. Which option describes the reason for this?

An engineer has performed a post-installation site survey using Ekahau Site Survey with a recommended adapter. Which two metrics can be different between the adapter used to survey...

A wireless phone user is having roaming difficulties and is experiencing gaps in the conversation while roaming. WLC WLAN is configured as IEEE 802.1X and WPA2 and Aironet informat...

Which three WLC actions are needed to properly enable queuing with TSPEC for voice traffic?(choose three)

You perform the initial RF plan for a site with ID26496007 by using Cisco Prime Infrastructure. Which two actions improve the real-time handoff?

While preparing to perform a wireless site survey on a site with ID26496007 , an engineer acquires an autonomous access point of the model specified by the client for the future de...

An engineer must enable 5 GHz on the voice for Cisco 7925 phones. Which change must be made in the TPC configuration page?

Which description of Cisco Centralized Key Management is true?

A university is in the process of deploying a wireless network in an auditorium that seats 500 students and supports student laptops. Which deployment methodology should the univer...

An engineer is tasked with designing a WLAN. The customer is prioritizing data speeds to the desktop, but is also entertaining the idea of adding 802.11 phones in the future. Given...

Which tool in the cisco prime infrastructure can you use to identify whether an existing network can support RFID tags?

Which three reasons describe the importance of assessing existing wired infrastructure when designing a new wireless network? (choose three)

An engineer must implement a cabling infrastructure that supports speeds up to 10G, can run a good distance before cable loss, and can support IEEE8.2.11ac speeds. Which infrastruc...

You are using Ekahau Site Survey to plan a WLAN. Which image format is scaled automatically during the map import process?