300-360 Exam Questions

As part of a wireless site survey in a hospital, an engineer needs to identify potential Layer 1 interferers. In which three areas is the engineer most likely expect to find source...

A customer has dual-band devices that they want to use 40 MHz channels. If the customer is using Cisco 3600 Series access points with a 5508 controller. Which setting assists with...

An engineer is installing a wireless network in an industrial area with extreme temperatures and a significant amount of dust. Which enclosure should be used to protect the APs?

Which list of characteristics must all controllers in a mobility group have in common based on best practices?

When conducting a wireless survey at a customer facility, signal attenuation in an area that is surrounded by thick glass walls is noted as 2dB. When configuring Cisco Prime Infras...

An engineer is assigned to replace an older data-grade autonomous wireless network with a Cisco controllerbased wireless network to meet Voice over WLAN needs. The customer also wa...

An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?

Refer to the exhibit. While testing the post-deployment WLAN network, you discover that an AP has been placed in a difficult area. The AP cannot be moved easily because of various...

A customer is deploying a mesh outdoor wireless network based on FCC standards where spectrum analysis shows significant radar energy propagating throughout the coverage area from...

An engineer must perform a survey where the target client devices range from standard Wi-Fi- equipped laptops, consumer handhelds and tablets, and low power tracking tags limited t...

When reviewing a design for a voice over wireless deployment, what per-call bandwidth cost should be factored in when determining maximum calls per cell using SIP and G.711u as the...

Which two factors influence the density of APs in a data-only WLAN environment? (Choose two.)

Which type of information should be included in an installation report?

Which two pieces of physical infrastructure information should be included in the installation report presented to the customer? (Choose two.)

Which two factors influence the density of APs in a data-only WLAN environment? (Choose two.)

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?

What is the result if a client radio is incapable of supporting all the 5 GHz channels you have deployed in the controller or APs?

If you are calibrating for 2.4 GHz and the site will not be using 802.11 and 802.11b data rates, what should be done to ensure an accurate calibration?

What two factors could cause a post-deployment audit to show a high retransmission rate for the WLAN? (Choose two.)

When designing a WLAN, AP placement is important. How would you rank the density of APs needed to support location services versus data and voice services?

An engineer is configuring a new VoWLAN and wants only IEEE 802.11g/n to be supported. Which two data rates should be configured? (Choose two.)

An engineer has been assigned the task of deciding the cell overlap for a wireless voice deployment. Which Cisco measurement recommendation should be considered?

Which three components and tasks should be considered while planning the site survey? (Choose three.)

A customer reports that wireless clients are not able to receive multicast data from known working multicast servers on the wired network. The client is connecting at the highest m...

After implementing mesh with an IP surveillance camera connected to the LAN port on a RAP, the engineer notices that QoS is not being marked. In this setup, what device is responsi...

When calculating bandwidth usage for an application, what two values represent the minimum and maximum 802.11 overhead per frame? (Choose two.)

When planning to perform a customer WLAN site survey, which three components and tasks should be considered? (Choose three.)

Which option will allow the maximum 2.4 GHz channel usage for a survey and voice deployment in the ETSI domain?

A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Som...

Clients are experiencing artifacts in multicast video even though the network was recently upgraded to 802.11n APs. What three configuration changes will be most effective to impro...

You have a multinational customer that would like you to perform a wireless site survey for a new manufacturing facility in Singapore. They have had a local vendor install a point-...

Refer to the exhibit. Which type of cable connector is displayed that is used to connect antennas to transmitters?

A customer is having issues streaming video over wireless in a few high-density areas of their campus. After further investigation, the administrator has singled out the issue pert...

Which two critical requirements must be addressed in the RF site survey for wireless video surveillance? (Choose two.)

When designing a large, high-availability wireless network, what changes to a mobility- group would create less load on the controllers while maintaining the same mobility messages...

After enabling global multicast, multicast traffic has been flooding the wired and wireless network. The wireless engineer has been troubleshooting and is attempting to find the so...

Which piece of information gathered during a WLAN site survey should be included in the customer report?

Which three statements describe WLAN RF interaction with environmental situations? (Choose three.)

A network engineer is having wireless multicast fail when it hits the wired network. What command will show the source of multicast groups for troubleshooting?

Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)

Given an AP that can transmit at 100 mW and the client at 40 mW, which power setting should be used for a site survey?

What protocol can be enabled to listen in on IPv4 multicast streams and maintain a map of what each client requests on a wireless LAN controller?

When implementing video teleconferencing over a wireless network, which three attributes should be considered when cell planning? (Choose three.)

A customer recently placed 10 WLCs in a mobility group and now sees a large amount of additional traffic to and from the controller. What setting should be changed to reduce the tr...

A wireless engineer is hired to design a network for six buildings with a WLC in each building to support the access points. Which type of wireless architecture is being used?

The ClO of a company wants to start tracking inventory in the warehouse using RFID tags and their existing wireless network. The company hires a wireless engineer to ensure that th...

IEEE 802.llk-2008 is an amendment to IEEE 80211-2007 standard for radio resource management. A wireless engineer is designing a wireless network to support real time applications o...

Which option is an advantage at using Cisco CleanAir technology in your wireless network?

You are designing a wireless network to support high user density in the 5 GHz spectrum. Which option is the benefit of selecting a channel width of 20 MHz instead of selecting a h...

Refer to the exhibit. An engineer has determined that Cisco 7925 phones are roaming between 2.4 6Hz and 5 6Hz radios on the same access points, which results in poor audio performa...