200-301 Exam Questions

Which Cisco IOS command will indicate that interface GigabitEthernet 0/0 is configured via DHCP?

Which command can you enter to allow Telnet to be supported in addition to SSH?

Refer to the exhibit. The default-information originate command is configured under the R1 OSPF configuration. After testing, workstations on VLAN 20 at Site B cannot reach a DNS s...

Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)

What is the binary pattern of unique ipv6 unique local address?

Refer to the exhibit. If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?

Which two statements about VTP are true? (Choose two.)

Refer to the exhibit. On R1 which routing protocol is in use on the route to 192.168.10.1?

Which two options are the best reasons to use an IPV4 private IP space? (Choose two)

Which type does a port become when it receives the best BPDU on a bridge?

Which value can you modify to configure a specific interface as the preferred forwarding interface?

Which statement about VLAN configuration is true?

Refer to the exhibit. Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?

Refer to exhibit. What Administrative distance has route to 192.168.10.1 ?

Which value is used to determine the active router in an HSRP default configuration?

Refer to the exhibit. If RTR01 is configured as shown, which three addresses will be received by other routers that are running EIGRP on the network? (Choose three)

Which configuration command can you apply to a HSRP router so that its local interface becomes active if all other routers in the group fail?

Refer to the exhibit. After you apply the given configuration to a router, the DHCP clients behind the device cannot communicate with hosts outside of their subnet. Which action is...

Which two statements about eBGP neighbor relationships are true? (Choose two)

Which statement about Cisco Discovery Protocol is true?

Refer to the exhibit. How will the router handle a packet destined for 192.0.2.156?

Which technique can you use to route IPv6 traffic over an IPv4 infrastructure?

Which statements describe the routing protocol OSPF? (Choose three.)

Refer to the exhibit. After you apply the given configurations to R1 and R2 you notice that OSPFv3 fails to start. Which reason for the problem is most likely true ?

Which command is used to display the collection of OSPF link states?

Refer to the exhibit. A network associate has configured OSPF with the command: City(config-router)# network 192.168.12.64 0.0.0.63 area 0 After completing the configuration, the a...

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. Th...

Refer to the exhibit. Which address and mask combination represents a summary of the routes learned by EIGRP?

Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?

Refer to the exhibit. Which rule does the DHCP server use when there is an IP address conflict?

Refer to the exhibit. When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?

Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What...

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. The gr...

Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two.)

Refer to the exhibit. Which two statements are true about the loopback address that is configured on RouterB? (Choose two.)

What are two reasons a network administrator would use CDP? (Choose two.)

What are two benefits of using VTP in a switching environment? (Choose two.)

Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.)

Which three statements are typical characteristics of VLAN arrangements? (Choose three.)

If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?

The OSPF Hello protocol performs which of the following tasks? (Choose two.)

What are two requirements for an HSRP group? (Choose two.)

Which command can you enter to determine the addresses that have been assigned on a DHCP Server?

On a corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communicat...

Which IPv6 address block forwards packets to a multicast address rather than a unicast address?

What is the expected outcome when an EUI-64 address is generated?

What is the difference regrading reliability and communication type between TCP and UDP?

Which function dose the range of private IPv4 addresses perform?

Which purpose does a northbound API serve in a controller-based networking architecture?

How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?