200-301 Exam Questions

Refer to the exhibit. Which IPv6 configuration is required for R17 to successfully ping the WAN interface on R18? A. B. C. D.

Which type of organization should use a collapsed-core architecture?

What is a capability of FTP in network management operations?

Which AP mode serves as the primary hub in a point-to-multipoint network topology?

Which type of API allows SDN controllers to dynamically make changes to the network?

Drag and Drop Question Drag and drop the lightweight access point operation modes from the left onto the descriptions on the right. Answer:

Which protocol is used in Software Defined Access (SDA) to provide a tunnel between two edge nodes in different fabrics?

Which plane is centralized by an SDN controller?

Refer to the exhibit. Which next-hop IP address does Router1 use for packets destined to host 10.10.13.158?

A Cisco engineer must configure a single switch interface to meet these requirements: - accept untagged frames and place them in VLAN 20 - accept tagged frames in VLAN 30 when CDP...

Refer to the exhibit. An engineer is configuring the HO router. Which IPv6 address configuration must be applied to the router fa0/1 interface for the router to assign a unique 64-...

Which WLC management connection type is vulnerable to man-in-the-middle attacks?

Which action is taken by the data plane within a network device?

What is a function of a Next-Generation IPS?

Which characteristic differentiates the concept of authentication from authorization and accounting?

Which value is the unique identifier that an access point uses to establish and maintain wireless connectivity to wireless network devices?

Which QoS per-hop behavior changes the value of the ToS field in the IPv4 packet header?

Refer to the exhibit. Which route must be configured on R1 so that OSPF routing is used when OSPF is up, but the server is still reachable when OSPF goes down?

Refer to the exhibit. Users need to connect to the wireless network with IEEE 802. 11r-compatible devices. The connection must be maintained as users travel between floors or to ot...

Refer to the exhibit. What is a reason for poor performance on the network interface?

Refer to the exhibit. A network engineer must update the configuration on Switch2 so that it sends LLDP packets every minute and the information sent via LLDP is refreshed every 3...

Refer to the exhibit. Users on existing VLAN 100 can reach sites on the Internet. Which action must the administrator take to establish connectivity to the Internet for users in VL...

Refer to the exhibit. Packets received by the router from BGP enter via a serial interface at 209.165.201.1. Each route is present within the routing table. Which interface is used...

Refer to the exhibit. An engineer is configuring an EtherChannel using LACP between Switches 1 and 2. Which configuration must be applied so that only Switch 1 sends LACP initiatio...

Refer to the exhibit. R1 learns all routes via OSPF. Which command configures a backup static route on R1 to reach the 192.168.20.0/24 network via R3?

What is the difference between IPv6 unicast and anycast addressing?

Which protocol uses the SSL?

Which two spanning-tree states are bypassed on an interface running PortFast? (Choose two.)

A Cisco engineer is configuring a factory-default router with these three passwords: - The user EXEC password for console access is p4ssw0rd1 - The user EXEC password for Telnet ac...

How does Rapid PVST+ create a fast loop-free network topology?

Refer to the exhibit. The link between PC1 and the switch is up, but it is performing poorly. Which interface condition is causing the performance problem?

Which PoE mode enables powered-device detection and guarantees power when the device is detected?

What is an expected outcome when network management automation is deployed?

Refer to the exhibit. Which action must be taken to ensure that router A is elected as the DR for OSPF area 0?

Refer to the exhibit. Web traffic is coming in from the WAN interface. Which route takes precedence when the router is processing traffic destined for the LAN network at 10 0.10.0/...

Which two components comprise part of a PKI? (Choose two.)

What are two benefits of FHRPs? (Choose two.)

Refer to the exhibit. Which command configures OSPF on the point-to-point link between routers R1 and R2?

What causes a port to be placed in the err-disabled state?

Refer to the exhibit. An engineer is configuring a new router on the network and applied this configuration. Which additional configuration allows the PC to obtain its IP address f...

Which Layer 2 switch function encapsulates packets for different VLANs so that the packets traverse the same port and maintain traffic separation between the VLANs?

Refer to the exhibit. Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.)

Which type of IPv6 address is similar to a unicast address but is assigned to multiple devices on the same network at the same time?

Which two network actions occur within the data plane? (Choose two.)

Which QoS traffic handling technique retains excess packets in a queue and reschedules these packets for later transmission when the configured maximum bandwidth has been surpassed...

Refer to the exhibit. All traffic enters the CPE router from interface Serial0/3 with an IP address of 192.168.50.1. Web traffic from the WAN is destined for a LAN network where se...

Which interface mode must be configured to connect the lightweight APs in a centralized architecture?

Refer to the exhibit. Which two commands must be configured on router R1 to enable the router to accept secure remote-access connections? (Choose two)

Which type of network attack overwhelms the target server by sending multiple packets to a port until the half-open TCP resources of the target are exhausted?

Refer to the exhibit. An engineer assumes a configuration task from a peer. Router A must establish an OSPF neighbor relationship with neighbor 172.1.1.1. The output displays the s...