Refer to the exhibit. Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.)

The correct answer is A. R3(config)#interface fastethernet 0/0 C. R1(config)#interface fastethernet 0/0. R1 must have the Highest priority, and thus R3 a low or lowest Priority.

Submitted by kwame.gh· Mar 5, 2026IP Connectivity

Question

Refer to the exhibit. Which two configurations must the engineer apply on this network so that R1 becomes the DR? (Choose two.)

Exhibits

Options

AR3(config)#interface fastethernet 0/0
BR1(config)#router ospf 1
CR1(config)#interface fastethernet 0/0
DR1(config)#interface fastethernet 0/0
ER3(config)#interface fastethernet 0/0

How the community answered

(33 responses)

A
70% (23)
B
9% (3)
D
3% (1)
E
18% (6)

Explanation

R1 must have the Highest priority, and thus R3 a low or lowest Priority.

Topics

#OSPF DR election#OSPF priority#Cisco IOS configuration

Community Discussion

No community discussion yet for this question.

Full 200-301 Practice