352-001 Practice Questions
781 real 352-001 exam questions with expert-verified answers and explanations. Page 8 of 16.
- Question #359
To improve the stability of the network and protect it from intrusions, you must design control plane security. Which two features should you enable as part of this design? (Choose...
- Question #360
You are a network designer who must fine tune the convergence of an IS-IS network. The failure detection mechanism has been addressed with reliable loss-of-signal at the interface...
- Question #361
You must measure the amount of traffic that a mobile packet gateway produces when mobile phones access the service provider's internal applications, rather than the Internet. Backb...
- Question #362
Refer to the exhibit. You are designing MPLS-TE for this network. The links from Perth to Sydney and from Perth to Adelaide share the same optical fiber in one given segment. Which...
- Question #363
Refer to the exhibit. This network is running IS-IS as the single routing protocol and the LSP and SPF timers are aggressively configured so the network converges in subsecond. The...
- Question #364
Which two benefits does using virtual PortChannel technology provide? (Choose two).
- Question #366
Refer to the exhibit. RTR 1 uses RTR 2 as the primary WAN exit point. When a failure occurs in the link connected to RTR 2 LAN, it takes about 40 seconds for RTR 1 to use the backu...
- Question #367
Which three techniques can be used to provide IPv6 first-hop security to prevent man-in-the- middle attacks? (Choose three.)
- Question #373
Which Designated Intermediate System selection option is valid when deploying IS-IS in a broadcast medium that connects two networking devices as a point-to-point network type?
- Question #374
Which option describes an advantage of UDLD?
- Question #375
Which three options are important functions of IPv6 first-hop security? (Choose three.)
- Question #376
A customer is running OSPF on a broadcast network type in a DMVPN single-hub, single-cloud topology and dynamically routes from the data center to the branch networks. The customer...
- Question #377
Refer to the exhibit. After this new OSPF design with per-packet load balancing was implemented, Host A reported that large file downloads from Server A became slow and sometimes f...
- Question #378
On a large enterprise security solution, which two options are IDS or IPS modes of operation? (Choose two.)
- Question #379
Refer to the exhibit. Service Provider A has offered to help Service Provider B to provide local connectivity for a customer who has a business operation in North America and recen...
- Question #380
A large retail bank is designing a unified communications solution to be deployed to its 200 branches. Its current network traffic consists of a web-based portal, Internet browsing...
- Question #381
What is the definition of the FCAPS framework?
- Question #382
What are three tools for ongoing monitoring and maintenance of a voice and video environment? (Choose three.)
- Question #383
In an MPLS-based network, there is a link that constantly flaps. This flapping makes the network constantly reconverge and causes it to become unstable. Which two technologies can...
- Question #384
Refer to the exhibit. This OSPF network has just been deployed with four areas, but the hub-and- spoke area frequently flaps. You must fix this design failure. Which two reasons de...
- Question #385
While designing a security solution, which three requirements would make you decide to deploy an IPS sensor in inline mode? (Choose three.)
- Question #386
Refer to the exhibit. Assume that no multicast optimization is done on LAN switches A and B. Which two features can be used to optimize multicast traffic forwarding in this situati...
- Question #387
Refer to the exhibit. You are designing an MPLS network with Layer 3 VPNs, where the traffic path must be the same in both directions inside the MPLS network to ensure that symmetr...
- Question #388
You are designing an IEEE 802.1X solution for a customer, where the network supports a large number of IP phones and printers. You plan to configure MAC address bypass for the phon...
- Question #389
When you design a network that uses IPsec, where can you reduce MTU to avoid network fragmentation?
- Question #390
What is a characteristic of traffic shaping?
- Question #391
What is the purpose of dynamically created tunnels using IPv6 multicast?
- Question #392
Which ISAKMP feature could be used within your design recommendation to reduce device CPU load in a small scale setup for known active ISAKMP security associations?
- Question #393
Acme Corporation wants to minimize the risk of users plugging unauthorized switches and hubs into the network. Which two features can be used on the LAN access ports to support thi...
- Question #394
Which two OSPF network type combinations can you use in the design of a Phase 3 DMVPN that requires spoke-to-spoke direct traffic? (Choose two.)
- Question #395
Which mechanism can you use to improve network performance over PPPoE, IPsec, and GRE networks?
- Question #396
Which VPN technology supports multivendor interoperability on a network design?
- Question #397
A customer with a dedicated Frame Relay network plans to move its circuits onto a service provider converged MPLS network. Instead of moving to Ethernet access links right away, th...
- Question #398
Which multicast technology provides a large, many-to-many connectivity for a new application while minimizing load on the existing network infrastructure?
- Question #399
You are redesigning an OSPF v2 network and must migrate some links. You are concerned that there are different subnet masks. Which link type will still form an OSPF adjacency even...
- Question #400
To meet specific business requirements, QoS-marked traffic must be sent over a dedicated link. Which technology fulfills this requirement?
- Question #401
Which routing protocol supports unequal cost, multipath load balancing?
- Question #402
Which two options are considered risks or concerns when both the Internet and VPN service functions are on the same PE router? (Choose two.)
- Question #403
Which statement is correct about route reflector design?
- Question #404
Which two statements are correct about route redistribution? (Choose two.)
- Question #405
Which two options are benefits of moving the application development workload to the cloud? (Select Two)
- Question #406
In a typical three-node OpenStack deployment, which two components are part of the controller node? (Choose two )
- Question #407
In a Cisco ACI environment, which option best describes "contracts"?
- Question #408
Which two characteristics of an loT network are true? (Choose two.)
- Question #409
Which option is the common primary use case for tools such as Puppet. Chef. Ansible, and Salt?
- Question #410
Which two statements about the various types or DevOps tools are true? (Choose two)
- Question #411
Which two platforms provide hypervisor virtualization? (Choose two.)
- Question #412
A company will integrate an IPv6 application into their network and wants to develop a test environment to evaluate application performance across the network. This application con...
- Question #413
Which option forces traffic to take an explicit route across a backbone network?
- Question #414
A mobile network operator is designing an NGN backhaul and plans to migrate their legacy SDH and SONET-based transport network to a packet-based transport network. The NGN network...