SK0-004 Practice Questions
928 real SK0-004 exam questions with expert-verified answers and explanations. Page 6 of 19.
- Question #252
After a virus outbreak, which of the following can be used to deploy a hotfix in a Microsoft environment? (Select TWO).
- Question #253
Which of the following BEST describes RAID 10?
- Question #254
Which of the following BEST describes RAID 1?
- Question #255
Which of the following BEST describes RAID 0?
- Question #256
Which of the following BEST describes the difference between RAID 5 and RAID 6?
- Question #257
Which of the following BEST describes a benefit of RAID 0?
- Question #258
Which of the following BEST describes RAID 5?
- Question #259
Which of the following RAID levels provides the HIGHEST fault tolerance possible?
- Question #260
Which of the following is BEST described as a storage system that can be connected to multiple servers through a fiber channel?
- Question #261
Which of the following is a storage system that can be connected to multiple servers through an iSCSI connection?
- Question #262
Which of the following can be used to manage a servers BIOS remotely? (Select TWO).
- Question #263
Which of the following BEST describes a server where several physical server chassis are housed within an enclosure to share some redundant resources?
- Question #264
Which of the following memory technologies has the HIGHEST cost to implement?
- Question #265
A power loss during a firmware update would MOST likely result in which of the following?
- Question #266
Which of the following interfaces in Windows server can be used to add a new volume for storage? (Select TWO).
- Question #267
When an administrator is troubleshooting a system, which of the following describes the NEXT course of action if a change does not solve the problem?
- Question #268
Which of the following expansion cards should be installed into a server to provide fiber channel SAN connectivity?
- Question #269
Which of the following can occur if the maximum rated load is exceeded on an uninterruptible power supply (UPS)?
- Question #270
A server is having problems accessing its presented storage on a SAN. Which of the following could be causing the problem? (Select TWO).
- Question #271
Which of the following components found in a legacy server has a 16-bit bus?
- Question #272
Which of the following expansion slots would be BEST for a fiber network card?
- Question #273
Which of the following expansion slots is 64-bit?
- Question #274
Which of the following will allow devices to be added without turning the server off?
- Question #275
Which of the following internal storage devices has the GREATEST storage capacity and is WORM media?
- Question #276
Which of the following media types is the MOST durable in harsh environments?
- Question #277
Which of the following settings is the jumper set to when installing a DVD-RW as the second device on an IDE cable?
- Question #278
A user reports they cannot access the network share folder, the users workstation is configured to use automatic IP. When the administrator checks the IP address the response retur...
- Question #279
After applying a new driver to a NIC, the server reboots and fails to restart. Which of the following is the BEST way to resolve the problem?
- Question #280
Which of the following types of DNS records enables support for email?
- Question #281
Which of the following protocols is responsible for the resolution of IP addresses to MAC addresses?
- Question #282
Which of the following RAID levels supports fault tolerance by writing parity to only one drive in the array?
- Question #283
Which of the following are possible SCSI ID ranges on a wide SCSI adapter?
- Question #284
Which of the following RAID levels can withstand the simultaneous loss of two physical drives in an array?
- Question #285
Which of the following protocols would MOST likely be used in the establishment of an IPSec VPN tunnel?
- Question #286
Users have reported that they cannot access certain Internet sites. An administrator wants to test that the sites are properly resolving to an IP address. Which of the following to...
- Question #287
A new server was installed for the purpose of monitoring network traffic. The network has been configured in such a way that all traffic will be mirrored out the port this server i...
- Question #288
A server is connected to a gigabit Ethernet switch and has negotiated 1Gbps / Full Duplex. When transferring large files to and from other servers on the segment via FTP slow perfo...
- Question #289
A new server was installed. Most clients are located in the same subnet as the server and can successfully access the server. Clients located on different subnets have been unable...
- Question #290
Which of the following is an SLA?
- Question #291
A server failed Thursday evening before the nightly backup. The backup scheme in place was full backups every Sunday, incremental backups on Monday, Wednesday, and Friday, and diff...
- Question #292
An administrator identifies that a server is shutting down. The administrator powers up the server and OS loads but after a few minutes it powers down again. Which of the following...
- Question #293
Which of the following would be an advantage to using a blade server as opposed to a rack mount server?
- Question #294
A stripe set of maximum size is to be configured using two physical disks. One disk has 150GB and the other has 250GB in unallocated space. Which of the following will be the size...
- Question #295
A technician has a current baseline and is told to install additional memory and a faster NIC card. At which point in time should the next baseline be run?
- Question #296
Users report that they are unable to connect to a server. An administrator confirms that it is unreachable across the network. Other administrators have been working in the server...
- Question #297
A company utilizes the GFS backup standard. Which of the following describes this backup method?
- Question #298
Which of the following concepts is described as multiple logical subnets traversing the same physical network?
- Question #299
Which of the following expansion cards should be installed in a server to allow the server to connect to a SAN via a fiber channel?
- Question #300
Which of the following must be done to properly conduct testing of the data backup portion of a disaster recovery plan?
- Question #301
Which of the following is the MOST important consideration before making a change to a server?