You are planning to upgrade your SAP ECC 6.07 non-Unicode system to SAP ECC 6.08. How can you perform this upgrade? Please choose the correct answer.

Question

Options

• APerform the upgrade to SAP ECC 6.08 before the Unicode conversion.
• BCombine the upgrade and the Unicode conversion using the Twin Upgrade & Unicode Conversion
• CPerform the Unicode conversion before the upgrade to SAP ECC 6.08.
• DCombine the upgrade and the Unicode conversion using the Combined Upgrade & Unicode

• A
  10% (4)
• B
  15% (6)
• C
  73% (30)
• D
  2% (1)

Explanation

When upgrading a non-Unicode SAP ECC 6.07 system to ECC 6.08, the Unicode conversion must happen first because SAP ECC 6.08 does not support non-Unicode systems - attempting to upgrade directly (Option A) would fail since the target release mandates Unicode. Option B is incorrect because "Twin Upgrade & Unicode Conversion" is not a real SAP procedure; this term does not exist in SAP's toolset and is a fabricated distractor. Option D references the "Combined Upgrade & Unicode Conversion" (CU&UC), which is a real SAP procedure, but it is not supported for the ECC 6.07 → 6.08 upgrade path - CU&UC is only available for specific, older-to-newer release combinations where SAP has validated it. Therefore, the correct two-step sequence is: first convert the 6.07 system to Unicode, then perform the upgrade to 6.08.

Memory tip: Think "Unicode before Upgrade" - when the target release requires Unicode and CU&UC isn't an option, you must clean house (convert) before you can move house (upgrade).

No community discussion yet for this question.