What do you need to consider when performing the SI checks for an SAP S/4HANA conversion? Note: There are 2 correct answe rs to this question.

Question

Options

• AYou need to build up an SI check framework by applying SAP Notes.
• BThe errors from the SI checks must be solved; otherwise, SUM will report an error.
• CYou need an SAP system based on AS ABAP 7.50 or above for the SI check framework.
• DThe SI checks are executed in the development system and the results are transported into the

• A
  92% (22)
• C
  4% (1)
• D
  4% (1)

Explanation

A is correct because the Simplification Item (SI) check framework is not pre-installed - it must be activated in your source system by applying specific SAP Notes before the conversion can begin. B is correct because SI checks are mandatory gates: the Software Update Manager (SUM) validates these results and will block the conversion with an error if critical SI issues remain unresolved.

C is wrong because the SI check framework can be implemented on systems running AS ABAP versions lower than 7.50 (typically 7.02 or 7.31+) - version 7.50 is associated with the target S/4HANA system, not the prerequisite for running SI checks on the source. D is wrong because SI checks must be executed directly in the system being converted (e.g., production); results are not transported from a development system.

Memory tip: Think "Notes IN, Errors OUT" - you bring the framework in via SAP Notes (A), and you must drive errors out before SUM proceeds (B). Anything about version minimums or transporting results is a red herring.

No community discussion yet for this question.