An engineer must implement a Cisco Secure Internet Gateway by using Cisco Umbrella over a gateway site that has the NBAR protocol enabled. Which action is required after the tunnel interface is…

The correct answer is C. Set the probe path. In Cisco SD-WAN integrations with Cisco Umbrella Secure Internet Gateway (SIG), after you create and configure the tunnel interface in vManage for Umbrella SIG, you must define how the system will monitor and probe that tunnel so it can detect failures and do path selection…

SD-WAN Cloud Connectivity

Question

An engineer must implement a Cisco Secure Internet Gateway by using Cisco Umbrella over a gateway site that has the NBAR protocol enabled. Which action is required after the tunnel interface is configured on a Cisco vManage device?

Options

AConfigure VRF.
BSet the address family.
CSet the probe path.
DConfigure Network Based Application Recognition.

How the community answered

(29 responses)

A
3% (1)
B
7% (2)
C
86% (25)
D
3% (1)

Explanation

In Cisco SD-WAN integrations with Cisco Umbrella Secure Internet Gateway (SIG), after you create and configure the tunnel interface in vManage for Umbrella SIG, you must define how the system will monitor and probe that tunnel so it can detect failures and do path selection. This is done by setting the probe path on the tunnel interface.

Topics

#SIG#Cisco Umbrella#NBAR#probe path

Community Discussion

No community discussion yet for this question.

Full 300-440 Practice