Cisco
300-440 · Question #64
An engineer needs to configure Cisco Catalyst SD-WAN connectivity between an on-premises data center and AWS. The GigabitEthernet1 interface is used for public Internet connectivity, and the GigabitEt
The correct answer is A. encapsulation dot1Q 1832. The command encapsulation dot1Q 1832 is required for the subinterface GigabitEthernet1.1832 to enable VLAN tagging for VLAN 1832, which is necessary for AWS Direct Connect connectivity. This ensures proper Layer 2 encapsulation for the Direct Connect link.
SD-WAN Cloud Connectivity
Question
An engineer needs to configure Cisco Catalyst SD-WAN connectivity between an on-premises data center and AWS. The GigabitEthernet1 interface is used for public Internet connectivity, and the GigabitEthernet1. 1832 interface is used for AWS Direct Connect. This configuration was applied to the SD-WAN router: sdwan interface GigabitEthernet1 tunnel-interface color biz-internet allow-service all ! Which command completes the configuration?
Options
- Aencapsulation dot1Q 1832
- Bencapsulation ipsec
- Ctunnel mode sdwan
- Dtunnel source GigabitEthernet1.1832
How the community answered
(33 responses)- A82% (27)
- B9% (3)
- C3% (1)
- D6% (2)
Explanation
The command encapsulation dot1Q 1832 is required for the subinterface GigabitEthernet1.1832 to enable VLAN tagging for VLAN 1832, which is necessary for AWS Direct Connect connectivity. This ensures proper Layer 2 encapsulation for the Direct Connect link.
Topics
#AWS Direct Connect#dot1Q encapsulation#tunnel interface#SD-WAN
Community Discussion
No community discussion yet for this question.