300-365 Exam Questions
184 real 300-365 exam questions with expert-verified answers and explanations. Page 1 of 4.
- Question #1Mobility Deployment
What devices can be tracked with the Cisco Context Aware Services?
Context Aware Servicesdevice trackingMSElocation services - Question #2Wireless Deployment
After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network. Which feature can the admin use to restr...
mDNS gatewaymDNS-APservice discoverySSID restriction - Question #3Wireless Troubleshooting and Optimization
A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF p...
co-channel interferenceRF profileschannel width802.11ac - Question #4Wireless Deployment
A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.)
passive clientstatic IPDHCP requiredWLAN configuration - Question #5Wireless Deployment
An engineer used an interface group under the SSID configuration, but noticed that a test client is getting an IP assigned in a different VLAN from the DHCP server. Which two optio...
interface groupsAP groupsAAA overrideVLAN assignment - Question #7Wireless Deployment
A customer requires that the remote site be able to utilize local servers when the AP is in WAN- down (standalone mode). Which AP mode must be configured on the wireless controller...
FlexConnectstandalone modeWAN failoverAP modes - Question #8Wireless Troubleshooting and Optimization
A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action re...
channel utilizationCCK data rateshigh density802.11b - Question #9Guest Access Deployment
CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two)
CMX Facebook WiFiguest accesspre-authenticationHTTP traffic - Question #10Mobility Deployment
You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WL...
FlexConnect fast roamingCCKMlocal switchingFlexConnect groups - Question #11Wireless Deployment
What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?
PIMBSRmulticast RP discoverywireless multicast - Question #12Wireless Deployment
An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
FlexConnectWAN latencylocal switchinglocal authentication - Question #13Wireless Deployment
A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)
LAGEtherChannelWLC port configurationlink aggregation - Question #14Mobility Deployment
By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?
MSEWLC echo responsemobility servicesneighbor timeout - Question #15Wireless Troubleshooting and Optimization
A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu ut...
wireless multicastIGMP snoopingmulticast-multicast modeCPU optimization - Question #16Wireless Deployment
A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal?
interface groupsAP groupsSSID mappingVLAN interfaces - Question #17Mobility Deployment
Controllers WLC_1 and WLC_2 are in the same mobility group. A wireless client that does not have the same VLAN interface roams from WLC_1 to WLC_2. What happens to the client roami...
inter-controller roamingmobility groupsclient contextVLAN mismatch - Question #18Wireless Troubleshooting and Optimization
A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to c...
wireless multicastunicast AP multicast modeWLC CPUscalability - Question #19Wireless Deployment
Which two options are limitations of using an AP as a workgroup bridge? (Choose two.)
workgroup bridgeWGB limitationswired client limitVLAN support - Question #20Wireless Deployment
Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)
MAPcontroller discoveryAWPPEthernet boot sequence - Question #21Mobility Deployment
You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages...
NMSPMSEfirewall portsWLC communication - Question #22Wireless Deployment
When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)
VoWLANQoS markingDSCPbroadcast call - Question #23Wireless Troubleshooting and Optimization
A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache?
mDNS gatewayBonjourunicast replyWireshark - Question #24Wireless Deployment
An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this?
NetFlowPrime Infrastructurenetwork monitoring - Question #25Mobility Deployment
Which statement about when you configure FlexConnect APs and you want to set up Cisco Centralized Key Management fast roaming is true?
FlexConnectCCKMfast roamingFlexConnect groups - Question #26Wireless Deployment
Refer to Exhibit. A wireless client is connecting to FlexAPI which is currently working standalone mode. The AAA authentication process is returning the following AVPs: Tunnel-Priv...
FlexConnectAAA VLAN assignmentstandalone modeRADIUS AVP - Question #27Wireless Deployment
The customer has deployed C7960 phones with clients connected to them. What switch feature could be enabled to distinguish IP voice traffic from client data traffic?
Voice VLANIP telephonyswitch configurationQoS - Question #28Wireless Deployment
An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area. Which two...
CACload-based admission controlVoWLANQoS - Question #29Wireless Deployment
A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is levera...
FlexConnectSmart AP Image Upgradeimage transferFlexConnect master AP - Question #30Mobility Deployment
What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?
NMSPMSEecho intervallocation services - Question #31Wireless Deployment
Which show command will show whether a WLAN is locally or centrally switched on a Cisco Wireless Lan Controller?
FlexConnectcentral switchinglocal switchingshow commands - Question #32Wireless Troubleshooting and Optimization
You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0 firmware), 7921G, and...
VoWLANCACTSPECWMM - Question #33Wireless Troubleshooting and Optimization
Scenario There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the...
AP GroupsWLC configurationdynamic AP managementFlexConnect troubleshooting - Question #34Guest Access Deployment
A network engineer must ensure that corporate wireless users have a better experience than guest wireless users. Which two configurations fulfil requirement? (Choose two.)
QoS policyWLAN differentiationplatinum QoSbronze QoS - Question #35Wireless Deployment
A customer requires wireless traffic from the branch to be routed through the firewall at corporate headquarters. There is a RADIUS server in each branch location. Which FlexConnec...
FlexConnectcentral switchingcentral authenticationbranch deployment - Question #36Mobility Deployment
Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?
RF fingerprintinglocation trackingMSECisco location services - Question #37Wireless Deployment
A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are...
N+1 high availabilityCleanAirAVCinter-controller design - Question #38Wireless Deployment
VoWLAN implementation plans for a current mix of existing Cisco Unified Wireless IP Phones 7920G and 7921G to a final migration of Wireless IP Phones 7925G in a single WLAN. What w...
VoWLANCACWMMphone migration - Question #39Wireless Troubleshooting and Optimization
After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series...
inter-controller roamingvoice roaming delaycentralized deploymentAP placement - Question #40Wireless Deployment
A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be u...
interface groupsDHCP scalabilitylarge-scale SSIDsubnet sizing - Question #41Guest Access Deployment
A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple i...
interface groupsWLC interfacessubnet sizingguest network scaling - Question #42Wireless Deployment
An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
AVCQoS overrideapplication visibilityWLAN profile - Question #43Wireless Deployment
A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped?
DSCPCoSQoS mappingtraffic marking - Question #45Wireless Troubleshooting and Optimization
A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details h...
MSE appliancepassword recoveryappliance management - Question #46Wireless Troubleshooting and Optimization
A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum...
optimized roamingRRMcoverage threshold802.11a CLI - Question #47Wireless Deployment
A network engineer for a college dormitory notices that student devices are filling up the SP-DB and are not allowing the shared wireless printers to be discovered. Which feature c...
mDNSBonjour gatewayPriority MACservice discovery - Question #48Mobility Deployment
You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availabil...
VoWLANSRSTQoS WANIP phone licensing - Question #49Wireless Troubleshooting and Optimization
A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.)
QBSSWMMCAC802.11e QoS - Question #50Wireless Deployment
A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference. Which configuration best fu...
DCAchannel planningco-channel interference5GHz density - Question #51Mobility Deployment
Refer to Exhibit. What two items need to be supported on the VoWLAN phones in order to take full advantage of this WLAN configuration? (Choose two.)
VoWLANWMM802.11eQoS phone requirements - Question #52Mobility Deployment
What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN?
SIPCACVoWLAN QoScall snooping