HPE2-W09 Exam Questions
127 real HPE2-W09 exam questions with expert-verified answers and explanations. Page 1 of 3.
- Question #1
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpoint (VTEP) that uses EVPN? Solution: MAC/IP advertisement routes advertise the MAC addresses that...
- Question #2
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpoint (VTEP) that uses EVPN? Solution: IMET routes advertise the MAC addresses that the VTEP has le...
- Question #3
A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX) at the core? Solution: The agg...
- Question #4
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct? Solution: The IPv6 and IP...
- Question #5
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct? Solution: Different virtu...
- Question #6
Refer to the exhibit. You want to enable devices in VRF B and VRF C to reach shared resources in VRFA. is this a valid strategy for meeting this goal? Solution: Create a separate O...
- Question #7
Refer to the exhibit. You want to enable devices in VRF B and VRF C to reach shared resources in VRF A. is this a valid strategy for meeting this goal? Solution: Place ad three VRF...
- Question #8
Can you attach this type of ArubaOS-CX interface to a VRF? Solution: A Layer 3 VLAN interface
- Question #9
An ArubaOS-CX is \ssmq DCBX on Interface 1/1/1. You enter this command: show dcbx interface 1/1/1 Is this where you can see whether the connected converged network adapter (CNA) ha...
- Question #10
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hos...
- Question #11
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hos...
- Question #12
Switch-1 and Switch-2 are AruDaOS-CX switches, which are part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure wh...
- Question #13
Is this a difference between a typical data center network's requirements and a typical campus network's requirements? Solution: Data center networks are typically less oversubscri...
- Question #14
Does this correctly describe the ArubaOS-CX architecture? Solution: The AtubaOS-CX software is based on the ArubaOS-Switch software and adds data center features.
- Question #15
Does this correctly describe the ArubaOS-CX architecture? Solution: The ArubaOS-CX time-series database helps to support network analytics and troubleshooting.
- Question #16
Is this a way that Virtual Switching Extension (VSX) differs from Virtual Switching Framework (VSF)? Solution: VSX permits admins to select which features to synchronize between me...
- Question #17
Is this a way that a data center technology can help meet requirements for multi-tenancy? Solution: Virtual Extensible LAN (VXLAN) enables multiple isolated Layer 3 domains, each w...
- Question #18
Is this a way that a data center technology can help meet requirements for multi-tenancy? Solution: Virtual Extensible LAN (VXLAN) provides millions of IDs to scale for the needs o...
- Question #19
Refer to the exhibit. Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwa...
- Question #20
Refer to the exhibit. Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwa...
- Question #21
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches? Solution: Different switches have different limitations for the number of NAE script...
- Question #22
You need to integrate Aruba Fabric Composer (AFC) with customer datacenter software. Is this integration possible? Solution: Aruba Fabric Composer (AFC) with Nutanix Hypervisor (AH...
- Question #23
Refer to the exhibits. Is this how the switch handles the traffic? Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-...
- Question #24
Refer to the exhibits. Is this how the switch handles the traffic? Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to V...
- Question #25
Refer to the exhibits. Is this how the switch-1 handles the traffic? Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to...
- Question #26
Refer to the exhibits. Is this how the switch-1 handles the traffic? Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to...
- Question #27
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring? Solution: Combine multiple links between two data c...
- Question #28
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is inte...
- Question #29
Is this something that NetEdit 2.0 does after it discovers a switch? Solution: It collects Information about the switch hardware.
- Question #30
Is this something that NetEdit 2.0 does after it discovers a switch? Solution: It enables the switch REST API Interface, if disabled.
- Question #31
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: You are not concerned about split brain Issues...
- Question #32
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: In situations in which the primary switch fails...
- Question #33
Does this correctly describe NetEdit's notification capabilities? Solution: NetEdlt can send an error link to admins through ServlceNow.
- Question #34
Does this correctly describe NetEdit's notification capabilities? Solution: NetEdit notifies admins of errors using Its Internal email server.
- Question #35
You enter this command on an ArubaOS-CX switch: Switch# show erps status ring 1 Is this what the specified status means? Solution: The status is Pending, which means that the ring...
- Question #36
You need to integrate Aruba Fabric Composer (AFC) with customer datacenter software. Is this integration possible? Solution: Aruba Fabric Composer (AFC) with HPE StoreServ Manageme...
- Question #37
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hos...
- Question #38
Is this something that NetEdit 2.0 does after it discovers a switch? Solution: It enables SNMP on the switch, if disabled.
- Question #39
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches? Solution: You can run NAE with VSX, but only the primary VSX member will actually ru...
- Question #40
Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches? Solution: You can check whether a switch has reached its NAE limitations with the "s...
- Question #41
Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches' link-up delay settings? Solution: The link-up dela...
- Question #42
A customer's servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements? Solution: Us...
- Question #43
Is this a difference between a typical data center network's requirements and a typical campus network's requirements? Solution: Data center network traffic flows are typically eas...
- Question #44
Refer to the exhibit. Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwa...
- Question #45
Refer to the exhibit. Switch-1 and Switch-2 ate ArubaOS-CX switches that implement VXLAN WITHOUT Ethernet VPN (EVPN). Switch-2 uses the same VNI-to-VLAN mappings as Switch-1. Is th...
- Question #46
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: In situations in which the primary switch fails...
- Question #47
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: You want an admin to manually fail traffic over...
- Question #48
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric? Solution: You want to prevent any possibility of a split...
- Question #49
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch? Solution: If the profile mixes strict priority scheduling with another scheduling algorithm, the strict pr...
- Question #50
Refer to the exhibit. You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be...