Drag and Drop Question After HPE Superdome Flex deployment and nPar setup, you need to verify health status of HPE Superdome Flex components. Put the steps on the left into the coned order on the…

Question

Exhibit

Answer Area

Explanation

HPE Superdome Flex Health Verification - Step Explanation

Correct Order & Why

1. Open SSH client

This is the mandatory first step because all remote management of HPE Superdome Flex is done through a secure, encrypted connection. SSH (Secure Shell) is the protocol used to communicate with the RMC (Remote Management Controller). Without launching an SSH client first, you have no tool to establish a connection. Nothing else is possible until this is running.

Common mistake: Assuming you can use a web browser or serial console as a substitute - in this workflow, SSH to the RMC is the prescribed method.

2. Open session to RMC

Once the SSH client is open, you connect it to the RMC (Remote Management Controller) - the dedicated management controller on the Superdome Flex that handles out-of-band hardware monitoring. This establishes the authenticated session. You must be logged into the RMC before you can issue any management commands, including health checks.

Common mistake: Confusing the RMC session with an OS-level SSH session to a partition. These are different endpoints - the RMC is separate from the nPar OS environment.

3. Enter show health command

With an active RMC session established, you now have access to RMC CLI commands. The show health command queries the RMC for the status of all monitored hardware components (processors, memory, I/O, power, cooling, etc.). You must be inside the RMC session for this command to be valid - it does not exist at the OS level.

Common mistake: Running show health before fully authenticating into the RMC session, which will result in a command-not-found or access-denied error.

4. Confirm health status

This is the verification/validation step. After the show health command returns output, you read and interpret the results - looking for any components flagged as degraded, failed, or in a warning state. Only after reviewing the output can you confirm whether the system is healthy and the deployment is good.

Common mistake: Treating this as automatic - the command running without errors does not mean all components are healthy. You must actively read the output and confirm each component's reported status.

Summary

The order follows a strict access → authenticate → query → verify pattern, which is standard for any out-of-band hardware management workflow:

Each step is a prerequisite for the next - you cannot skip or reorder any of them.

No community discussion yet for this question.