D-NWG-FN-23 Exam Questions

How will RIP treat packets that have exceeded the default maximum hop count?

Which sequence represents a TCP half closed session?

What is the aggregated lanes' maximum speed rating for a QSFP28 transceiver?

A client must connect a printer located on a public area on an X1000. The client is concerned someone will use the printer Ethernet cable to gain unauthorized network access. Which...

Root bridge Switch A is connected to Switch B. They are connected using the same corresponding interfaces Gi1/01 and Gi1/0/2 on both sides. Which interface becomes a root port?

Which LLDP-MED TLV communicates DSCP values?

What are the mandatory TLV fields in a LLDP PDU frame?

How many discrete LAN networks are shown in the graphic?

Which port states are used in both spanning tree and rapid spanning port tree protocols?

Which protocols use a central server to authenticate users?

Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?

You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classroo...

Which is the slowest standard that a CAT6 cable supports?

What is the default route preference value for a Border Gateway Protocol (BGP) internal route?

A technician needs to configure a static LAG between two N-Series switches. Each LAG must consist of interfaces GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. Which commands shou...

Refer to the exhibit and output. Which change should be made to meet this requirement?

A technician must deploy powering source equipment at a customer site. Which equipment should the technician deploy?

Which topology is considered a best practice when stacking switches?

Which BASE-T Ethernet standard specifies a CAT6 cable type?

Which criteria is used to define an extended MAC ACL filter?

A Dell N2024 switch receives a frame from a directly connected host. The switch learns that the source MAC address is NOT present in the MAC address table. The destination address...

How many assignable IP addresses are in a Class C subnet?

Which port type does a Dell EMC Networking N-Series switch have for its console connection?

Which Dell EMC Networking M-Series switch has 16 external fixed 1GbE RJ-45 ports and a management console port?

Which OS10 command is used to enable LLDP transmit on the management interface 1/1/1?

Which option is described as a Stat Frame Delimiter (SFD) in an Ethernet frame?

Which port and protocol is used by NTP to communicate?

What is the convergence time for the Routing Information Protocol (RIP)?

Which address is a valid 802.3 MAC address?

Which route would a Layer 3 switch choose if a packet has a destination IP address of 172.16.2.70?

A technician is applying a switch configuration to an N-Series switch to provide Internet access to all connected subnets. The technician has connected a computer and assigned it a...

What is required for a LAG to be configured?

Which address is an IPv4 Broadcast address?

A client needs to allow Telnet traffic from the 192.168.1.0/25 network. The client needs to configure the "permit" statement in the ACL. Which command will accomplish this goal?

Which IEEE 802.3 sublayer provides addressing and mechanisms that enable network devices to communicate, and provides node-to-node flow control and error management?

A technician needs to create multiple subnets to make sure there are at least 20 available IP addresses per subnet. Which three subnets meet the requirements for the 172.21.254.0/2...

What is the bandwidth of an RPM for a C9010 Network Director?

Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is vis...

Two hosts are able to ping each other when directly connected. When the hosts are connected to ports Gi1/0/1 and Gi1/0/2 on a Dell EMC Networking N-Series switch, the process fails...

What is a characteristic of Autonomous Systems?

Which Ethernet frame forwarding method works best in networks with intermittent connectivity problems?

Which fields are mandatory TLVs in a LLDP PDU frame?

Refer to the output: spanning-tree mode mst spanning-tree mode mst configuration revision 1 instance 1 add vlan 2-4 instance 2 add vlan 5-10 exit A technician needs to add a new sw...

An N-Series switch is configured to route between VLANs 1 and 2. The DHCP server is on VLAN1. How should the technician make sure the DHCP server can allocate IP addresses to clien...

Refer to the output. Which two actions occur if interface Tw2/0/2 goes down? (Choose two.)

Which option is used to configure Network Address Translation (NAT) so that a large number of private IP addresses can be mapped to a few public addresses?

A customer is using the following subnets in their environment: - Desktops 192.168.1.0/24 - Servers192.168.2.0/24 - Printers 192.168.7.0/24 - DMZ 172.16.10.0/24 The customer has ru...

How many layers are in the TCP/IP model?

Which IPv6 scope is used for private addressing on a local network?

Which command is used to verify the DHCP configuration on a Microsoft Windows client?