D-NWG-FN-23 Exam Questions

What attributes does LLDP use to send and receive information about directly connected neighbors?

Which OS6 command is used to verify the running configuration on port 4?

A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?

Refer to the exhibit. A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The new switch routing table is NOT populating even after...

How is outbound traffic distributed when using LACP port channels on OS6 switches?

A static route is denoted with which flag in the routing table?

A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of th...

Which type of domains are connected by a Layer 2 switch?

Which command is available in OS6 to verify jumbo frames?

What accurately describes IPv6 addressing?

A dell Networking N-Series has configured a port-channel with LACP using the interfaces Tel/0/1 and Tel/0/2. How is the egress traffic distributed among the interfaces?

Which route type is added to the routing table by a routing protocol?

Which nanometer range will an SFP work in multi-mode?

Which operating system does an N-Series switch use?

A service technician is deploying four Dell N-Series switches in a company's network. The technician has enabled the spanning tree protocol on the switches. Which switch would the...

Which formula is used for calculating OSPF interface costs?

What are the required commands to configure a native VLAN of 10 and a tagged VLAN of 20 on an OS6 switch?

If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?

Which Layer 2 technology is used to segment a switched network?

How many total addresses for network, broadcast, and host are provided with the subnet mask 255.255.255.240?

A technician implements a new copper connection to Gi2/0/20. Which command should be used to check the cable length?

Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

A technician has one stack of three N3024. The technician removes the master unit without powering off the stack. This unit is reconfigured with new IP address in the same Layer 2...

Refer to the output: How has OSPF been configured?

A technician wants to allow SSH connections to authenticate using an external server. If the external server becomes unreachable, the users created on the switch should be allowed....

Which subnet mask provides only two valid IP addresses that can be assigned to hosts?

What are the Protocol Data Units (PDUs) called at the Transport layer?

Which network device functions only at Layer 1 of the OSI model?

What accurately describes the Simple Network Time Protocol (SNTP)?

In IPv6 addressing, what refers to four binary characters?

Which command is used to prevent STP learning on a port that is connected to a server?

What action needs to be performed to enable SSH on a new switch?

Which of the following is an IPv4 address?

A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients. Which IPv6 address prefix will the default gateway have on a client?

A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb link...

Which command shows active telnet sessions on Dell N-Series switches?

What criteria is used to determine STP root elections?

What is a valid subnet mask?

Which command enables the read-write network monitoring community string?

Refer to the output: console#show interfaces switchport te1/0/1 Port: Te1/0/1 VLAN Membership Mode: General Mode Access Mode VLAN: 1 (default) General Mode PVID: 9 General Mode Ing...

Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

What is administrative distance value for default static routes?

What accurately describes the Network Time Protocol (NTP)?

What accurately describes the comparison between stacking and VLT?

A network admin wants to secure SNMP access to the switch using an ACL named SPLUNKSRV. Which command will accomplish this task?

On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?

Which switchport command must be applied to an interface to allow Voice VLAN configurations?

What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

You have been tasked with designing an IPv4 scheme for the 192.168.40.0/24 network. What subnet mask can be used to produce at least five networks that can each support 28 hosts?