Dell-EMC
D-NWG-FN-23 · Question #4
Refer to the exhibit. A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The new switch routing table is NOT populating even after the correct…
The correct answer is D. The existing switch is configured to send and receive only for RIPv1. See the full explanation below for the reasoning.
Question
Refer to the exhibit. A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The new switch routing table is NOT populating even after the correct network statements are added. What is causing this issue?
Exhibit
Options
- AThe new N-Series switch does not have "default-information originate" configured.
- BThe existing switch has been configured for "hostroutesaccept".
- CThe other switch is a root bridge and cannot form RIP relationships.
- DThe existing switch is configured to send and receive only for RIPv1.
How the community answered
(42 responses)- A10% (4)
- B19% (8)
- C2% (1)
- D69% (29)
Community Discussion
No community discussion yet for this question.