Where can you enter a rounding profile? Note: There are 2 correct answers to this question.

Question

Options

• ALot-sizing procedure
• BPurchasing info record
• CSource list
• DMaterial master

• A
  10% (2)
• B
  81% (17)
• C
  10% (2)

Explanation

In SAP MM, a rounding profile controls how order quantities are rounded to standard units (e.g., pallet multiples). It can be stored in the Purchasing Info Record (B) - under the purchasing-specific conditions for a vendor-material combination - and in the Material Master (D) - specifically in the MRP 1 view, where it applies broadly to planning runs. These two locations cover both the procurement-specific and the general MRP contexts.

Why the distractors are wrong:

• A (Lot-sizing procedure): Lot-sizing procedures define how quantities are calculated (e.g., lot-for-lot, fixed lot size) and have rounding values, but do not host a rounding profile object.
• C (Source list): The source list only defines valid supply sources for a material; it holds no quantity-rounding configuration at all.

Memory tip: Think "B–D = Buy & Data" - the Purchasing Info Record (buy-side, vendor-specific) and Material Master (master data, MRP-side) are the two places where the rounding profile lives. If an option isn't about purchasing conditions or master data, eliminate it.

No community discussion yet for this question.