350-030 Exam Questions
373 real 350-030 exam questions with expert-verified answers and explanations. Page 7 of 8.
- Question #301
How many bits in an 802.1Q tagged Ethernet frame are used for 802.1p priority?
- Question #302
Refer to the exhibit. In this 802.1Q tagged Ethernet frame, which block of bits, labeled A, B, C, and D, is used as VID? Cisco 350-030 Exam
- Question #303
Refer to the exhibit. In this IPv4 packet, which bits in the ToS byte are used for DSCP?
- Question #304
Refer to the exhibit. In this IPv4 packet, which bits in the ToS byte are used for IP precedence?
- Question #305
In which two circumstances would Cisco Unified Communications Manager accept inbound H.323 Cisco 350-030 Exam calls from unknown IP hosts? (Choose two.)
- Question #306
Refer to the exhibit. Using information that is provided in the Cisco IOS gatekeeper configuration and the show gatekeeper endpoint output, how will the gatekeeper route the call w...
- Question #307
Refer to the exhibit. What will be experienced by a PSTN caller when calling into this T1 PRI circuit? Cisco 350-030 Exam
- Question #308
Which set of SIP headers is mandatory in SIP requests?
- Question #309
Which statement regarding SIP requests or responses is correct?
- Question #310
Which statement about the offer/answer model of SDP is correct?
- Question #311
Which two mechanisms can be used to detect SIP calls that are hung or stuck in an incomplete state? (Choose two.)
- Question #312
Which statement correctly describes symmetric signaling in SIP?
- Question #313
Refer to the exhibit. The line that is shown in the exhibit appeared in the Cisco Unified Communications Manager trace for a SIP IP phone that deregisters frequently. What could be...
- Question #314
Which statement about the "Unknown Caller ID" service parameter in Cisco Unified Communications Manager configuration is true?
- Question #315
Which two media resources are not required by Cisco Unified Communications Manager for outbound early-offer support on SIP trunks? (Choose two.)
- Question #316
There are several methods to transport DTMF digits between SIP endpoints. Which three methods are supported by Cisco Unified Communications Manager? (Choose three.)
- Question #319
According to RFC 3551, where default mappings between RTP payload type numbers and encodings are defined, which RTP payload type corresponds to G.711 a-law encoding?
- Question #321
Which version of MGCP is used on a Cisco IOS MGCP gateway that is registered to Cisco Unified Communications Manager?
- Question #322
On a Cisco IOS MGCP gateway, which DTMF relay method uses MGCP NTFY messages to send digits to Cisco Unified Communications Manager?
- Question #323
Which SCCP message is used by an IP phone to inform Cisco Unified Communications Manager about the IP address and port number to be used for an incoming RTP stream?
- Question #324
When an IP phone that is using SCCP places an active call on hold, which SCCP message will be transmitted from the phone to Cisco Unified Communications Manager?
- Question #325
What is the proper Cisco IOS CLI command to configure an analog FXS port to be controlled by Cisco Unified Communications Manager using SCCP?
- Question #326
Refer to the exhibit. When an outbound call with a calling number of 2112 and a called number of 1001 is placed through a Cisco IOS router with these dial peers, what is the correc...
- Question #327
Which network port is not used by the Cisco Unified Presence client?
- Question #328
Refer to the exhibit. Which dial peer will the Cisco IOS voice gateway match if an incoming call with a calling number of 100 and called number of 101 arrives at this T1 PRI port?
- Question #329
Refer to the exhibit. Which two statements about this debug message that was captured from a Cisco IOS H.323 gateway are correct? (Choose two.) Cisco 350-030 Exam
- Question #330
Phone A, Phone B, and Phone C are configured to be in Device Pool A, Device Pool B, and Device Pool C, respectively. The Local Route Group feature was configured on Cisco Unified C...
- Question #331
Which MGCP message is used to indicate fax switchover in a call agent-controlled T.38 fax relay?
- Question #332
Refer to the exhibit. The debug that is shown was captured on a Cisco Unified Communications Manager Express router with FXO ports connecting to the PSTN. All incoming calls from t...
- Question #333
Refer to the exhibit. Which two DTMF capabilities are advertised in this SIP INVITE message? (Choose two.) Cisco 350-030 Exam
- Question #334
Refer to the exhibit. Which three header fields do not change for the duration of this call using SIP? (Choose three.) Cisco 350-030 Exam
- Question #335
Refer to the exhibit. What is the correct duration, in milliseconds, of the DTMF digit that is received?
- Question #336
What is required to back up Cisco Unified Presence configuration?
- Question #337
Which Cisco tool can be used to capture packets on Cisco Unified Presence?
- Question #338
Refer to the exhibit. User "jdoe" was not able to download voice mail with his Cisco Unified Personal Communicator. Which configuration change on the Voicemail Profile Configuratio...
- Question #339
Which three statements about the Outbound Dialer solution on Cisco Unified Contact Center Express are correct? (Choose three.)
- Question #340
Which two statements about the Agent Email feature on Cisco Unified Contact Center Express are correct? (Choose two.)
- Question #341
You have discovered that the Cisco Unified CM Telephony subsystem is in "PARTIAL_SERVICE" on a Cisco Unified Contact Center Express server. Which two misconfigurations could lead t...
- Question #342
After logging into Cisco Agent Desktop, a Cisco Unified Contact Center Express agent could not go into ready state. Which two reasons could lead to this failure? (Choose two.)
- Question #343
Which Cisco IOS command is used to define the size of the jitter buffer on Cisco IOS VoIP gateways?
- Question #344
Which three Cisco IOS commands can be used to verify configured playout delay values on Cisco VoIP gateways? (Choose three.)
- Question #345
Refer to the exhibit. Which statement about the QoS configuration for interface GigabitEthernet 1/0/1 on the Cisco Catalyst 3750 Series Switch is correct?
- Question #346
Refer to the exhibit. What is the correct expansion of the srr-queue abbreviation that is shown in the Cisco IOS command of the Catalyst 3750 Series Switch?
- Question #347
Which two statements about system broadcast messages on Cisco Unity Connection are correct? (Choose two.)
- Question #348
Which two statements about system broadcast messages on Cisco Unity Connection are correct? (Choose two.)
- Question #349
What is the maximum number of days for Cisco Unity Connection to retain expired system broadcast messages?
- Question #350
What is the maximum recording length that is allowed for system broadcast messages on a Cisco Unity Connection server?
- Question #351
Which of these is not a valid VPIM message addressing option that is provided by Cisco Unity Connection to individuals on a remote voice messaging system?
- Question #352
Which three call handlers are predefined on Cisco Unity Connection? (Choose three.)
- Question #353
Which greeting type is not a valid call handler on Cisco Unity Connection?