Refer to the Exhibit. The list of devices attached to vmhba1 will be the basis for configuring a VMware Virtual SAN using Manual Mode. Based on the exhibit, which two combinations of devices should…

A single disk group containing one flash drive as the cache tier and three HDDs as the capacity tier is a fully valid VSAN configuration that uses all available devices from the exhibit within one disk group.

Splitting the available flash and HDD devices into two disk groups - each with one flash drive and two HDDs - is equally valid; VSAN supports up to five disk groups per host, and distributing devices across groups can improve performance and fault isolation.

A single disk group with one flash drive and four HDDs is not achievable from the exhibit because the total HDD count shown does not support this layout without exceeding the available devices.

This option requires two flash drives and four HDDs per disk group, totaling four flash drives and eight HDDs, which far exceeds the number of devices visible on vmhba1 in the exhibit.