200-301 Question #687: Real Exam Question with Answer & Explanation

Question

Lab Simulation 5 Guidelines This is a lab item in which tasks will be performed on virtual devices. - Refer to the Tasks tab to view the tasks for this lab item. - Refer to the Topology tab to access the device console(s) and perform the tasks. - Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window. - All necessary preconfigurations have been applied. - Do not change the enable password or hostname for any device. - Save your configurations to NVRAM before moving to the next item. - Click Next at the bottom of the screen to submit this lab and move to the next question. - When Next is clicked, the lab closes and cannot be reopened. Topology Tasks All physical cabling between the two switches is installed. Configure the network connectivity between the switches using the designated VLANs and interfaces. 1. Configure VLAN 12 named Compute and VLAN 34 named Telephony where required for each task. 2. Configure Ethernet0/1 on SW2 to use the existing VLAN named Available. 3. Configure the connection between the switches using access ports. 4. Configure Ethernet0/1 on SW1 using data and voice VLANs. 5. Configure Ethernet0/1 on SW2 so that the Cisco proprietary neighbor discovery protocol is turned off for the designated interface only. Answer: Task#1: SW1: vlan 12 name Compute vlan 34 name Telephony Task#2: SW2: //First we must find vlan number of Available vlan "show vlan name Available" or "show vlan" or "show vlan brief" int e0/1 switchport mode access switchport access vlan Available Task#3: SW1: int e0/0 switchport mode access switchport access vlan 12 SW2: int e0/0 switchport mode access switchport access vlan 12 Task#4: SW1: int e0/1 switchport mode access switchport access vlan 12 switchport voice vlan 34 Task#5: SW2: int e0/1 no cdp enable Final > copy running-config startup-config

Explanation

This is a placeholder for a lab simulation question, which requires interactive configuration and troubleshooting tasks based on a specific topology and task list not provided in this format.

Concept tested. Lab simulation task execution

No community discussion yet for this question.